QIPEIZSP ‎9005+9006 Compatible With Honda Civic LED Bulbs Combo Instruction Manual

Operating Manual

‎9005+9006 Compatible With Honda Civic LED Bulbs Combo

H4

1. Separate LED headlight clamping holder from LED headlamp.
2. Fix headlight clamping holder on headlight clamping parts.
3. Rotate headlight and lock it.
4. Connect to circuit and turn on power.

Note:

1. Installation shall be completed by professional personnel.
2. Disconnect the negative pole of battery before installation.
3. Check if the wire box works well after installation. Check the parts tautness and if there are any parts missing.
4. Conduct atest over product function; feel free to contact us if you have any problems.

H11/9005/9006/880/H13/9004/9007

1. Match LED headlight clamping holder with headlight clamping slot.
2. Rotate headlight and lock it.
3. Connect to circuit and turn on power.

H7

1. Separate LED headlight clamping holder from LED headlamp.
2. Fix headlight clamping holder on headlight clamping parts
3. Rotate headlight and lock it.
4. Connect to circuit and turn on power.

LED Headlight Conversion Kit

Package Content
2x LED bulbassy. with drivers
1x Instruction
Attention: This instruction works for universal application, may not fit some models

Step 1
Take the original bulb off

A. Open up the engine cover
B. Find the headlamp and take it off. If you fail to take headlamp off, please seek professional help.
C. Take off the plastic or rubber cover to find headlamp bulb
D. Bulbs are fixed by latches or spring snaps. Release the latches and rotate bulb to take bulb off
E. Disconnect bulb with power socket

Step 2
Install and test
It is strongly recommended that users shall test the 2 LEDs before installation
Connect LED power line with auto mobile lamp plug. To prevent LED scratching, please do not install LED on head light; do not touch other parts out of headlight, or you may get scalded.
Connect LED with power socket, possible results:

A: If LED works, please fol low step 3.
B: If LED fails towork (H1 /H3 /H7/H8/H9 /H11 / 9005/9006/880/881), please disconnect it and adjust the positive/negative pole of plug.
C: If the LED fails (other models) to work.
I. Disconnect LED bulb with power socket on the car
II. Contact us for free replacement if you receive the wrong model
III. Contact us if you receive the wrong plug; once you receive the new product, please reconnect it to the socket for a test.
IV. If the bulb works, please follow step 3.
D: If LED keeps flickering, then you may have to install an extra decoding capacitor on your car, please follow the procedures as below:
I. Install decoding capacitor between driver and power plug.
II. Complete step 3.

Step 3
Complete Installation
After testing the bulbs, please install them to lamp assy head and tighten the spring snap.
For the spring snaps on the case of H4 and H7, extra procedures may need to be done for fixing hbulbs:

1. Release the base ring on bulb
2. Put bulb base ring on the right place of head lamp
3. Fix the bulb base ring with snap or spring
4. Get LED bulb through the base ring and instal led in the right place.

To prevent overheat, headlamp cover is not recommended.
If you want to install anewcover, it is strongly recommended that users shall cut a hole on the cover for better ventilation.
Take out all tools from the engine compartment, and close the engine cover.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>