enigma V10 600w Corded 3 In 1 Upright Handheld Stick Vacuum Cleaner Instruction Manual
- May 15, 2024
- enigma
Table of Contents
- enigma V10 600w Corded 3 In 1 Upright Handheld Stick Vacuum Cleaner
- ASSEMBLING THE VACUUM CLEANER
- INSTRUCTION FOR USE
- Using the cleaning accessories
- MAINTENANCE
- Troubleshooting
- BLOCKAGES – THIERMAL CTIT-OUT
- 1-Year Limited Warranty
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
enigma V10 600w Corded 3 In 1 Upright Handheld Stick Vacuum Cleaner
VACUUM CLEANER INSTRUCTION MANUAL
MODEL: Vl0
DESCRIPTION
- A. Power line
- B. Ovule Cover Button
- C. Power button
- D. Dust Cup button
- E. Dust .ip
- G. Ground brush
IMPORTANT
- Read this instruction booklet carefully.
- Before using the appliance, check that the mains power voltage corresponds to the voltage shown on the rating plate.
- The appliance should be connected to a correctly-earthed 10 power socket.
- Always remove the plug from the power socket when the appliance is not in use and before carrying out any cleaning or maintenance operations.
- Always remove the plug from the power socks before opening the appliance.
- Never use methylated spirits or other solvents to clean the appliance.
- Do not use the appliance to vacuum liquids. . Never leave the appliance unattended when it is switched on. Keep the appliance out ot the reach of children or the infirm.
- This appliances for domestic rise only. Use as describe din this instruction booklet.
- Do not switch the appliance on if it appears to be faulty in any way.
- For repairs or accessories. Contact your dealer or an authorized Service Center.
- If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
- Do not remove the plug from by pulling the cable the or appliance itself.
- Do not run the appliance over the power cable.
- Do not obstruct the air intake or outlet vent.
- Do not use the appliance on wet surfaces.
- Do not use the appliance to vacuum lighted matches, clgaretle ends or hot ash.
- Do not use the appliance to to vacuum neediest. drawing -pins or string.
ASSEMBLING THE VACUUM CLEANER
Assembly before operation
- Fitting the tube Insert the tube into the body.
- Fitting the floor brush Insert the brush into the tube
INSTRUCTION FOR USE
- The cable loose down after rotating the cable winding holder 180 degree, the plug insert the electrical outlet which the same as the nameplate; press the switch button, the vacuum cleaner begin working.
- Adjust the degree between brush and body by rotating the handle.
- Stop its working by press the switch button, disconnect the plug from outlet, rotate the cable winding holder 400 Daron to flu the noble
- Dual-position carpet/floor brush.
- Pos 1: bristles extended. for hard flo
- Pos. 2: bristles retracted for carpets
Using the cleaning accessories
Clean the dust
- Lift the from cover and take out the dust cup.
- Takeout thefoamfom1dust cup
- clean off the dust inside the dust cup
Clean the foam
- Take out the foam when it’s setting dirt’s
- clean it in the water .dry it naturally before next use.
MAINTENANCE
- Pull the plug out of the socket before cleaning
- Clean the appliance with a dry cloth.
- Take out the intake or outlet filter when it’s getting dirty. Clean it in warm water without any abluent and put it back when it is completely dry.
- If you don’t want to use this appliance for a period of time, store it on a dry and well ventilated place. Keep it out of reach of children.
DISPOSAL
Environmental Protection
Waste electrical production should not be disposed of with household waste.
Please recycle where facilities exist. Check with your Local Authority or
retailer of recycling advice.
Troubleshooting
BLOCKAGES – THIERMAL CTIT-OUT
- BLOCKAGES – THERMAL CUT-OUT
- This appliance is fitted with an automatically resetting thermal cut-out.
- If any part becomes blocked the appliance may overheat and automatically cut-out.
- If this happens, follow the instructions below in ‘Looking for blockages’.
- NOTE: Large items may block the tools or wand inlet. If this happens, do not operate the wand release catch. Switch ‘OFF’ and unplug. Failure to do so could result in personal injury.
- LOOKING FOR BLOCKAGES
- Switch ‘OFF’ and unplug before looking for blockages. Failure to do so could result in personal injury.
- Leave to cool down for 1-2 hours before looking for blockages.
- Beware of sharp objects when checking for blockages.
- Clear any blockage before restarting.
- Refit all parts securely before using.
1-Year Limited Warranty
enigma product is warranted to be free from defects in material and
workmanship under normal use and service for one year from the date of the
original purchase with the receipt. The manufacturer’s obligation shall be
limited to repairing or replacing any part of the product that is defective.
Such warranty shall not apply to damages resulting from accidents, abuse, or
misuse.
DISPOSAL INFORMATION
enigma products are made from high grade recyclable materials. Please dispose
of this product responsibly and recycle where possible. *Please note that not
all parts are recyclable. Recycling of parts is subject to the capabilities of
3rd party suppliers.
Chelsea Company Limited Corylus, Buttons Way ,Chalfont St Giles,HP8 4BP,UK
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>