Dumne 80005477 Automobile Remote Switch Relay User Manual
- May 15, 2024
- Dumne
Table of Contents
User manual
Automobile remote switch relay
M/N:80005477
Learning the code : ( Latching )
Note: When you choose for latching mode, in order to learn more remote contro,
you need to learn two different button, the first time learning is for “ON” ,
the second time learning for“OFF” .
For example : button A = ON , button B = OFF, Push the learning key on the
receiver triple time, it comes into latching mode. Wait for a moment, the LED
indicator on the receiver board will be on. Push the remote button A, LED
flash for 3 times.
Push the remote button B. LED indicator flash for 3 times and then come off,
learning successfully.
Wiring diagram
Relay parameters
Coil voltage
(VDC)| Coil
resistace
(Q±10%)| Pickup voltage
VDC(max.)| Release voltage
VDC(min.)| Coil Power| Operate
Time| Release
Time| Contact rating
(resistive)
---|---|---|---|---|---|---|---
Rated| Max.
12| 15.6| 60| 7.8| 1.2| 2.4W| 510ms| <5ms| 250A
Special reminder.
4.1.The receiver and the remote keys are already paired out of box.
4.2.When the device is not used for a long time(more than 10 days), the
circuit must be disconnected. if not, the voltage will be too low and the
device will not work properly.
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with _ the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
FCC RF Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>