Earphones K1 Neckband Earphone User Manual
- June 4, 2024
- Earphones
Table of Contents
Earphones K1 Neckband Earphone User Manual
Product Overview
Operation Instructions
- Long press the button of transmitter 2 seconds, the blue indicator blinks slowly, means boot up successfully.
- Long press the button of receiver 2 seconds, the blue indicator blinks slowly, means boot up successfully.
- Factory settings for transmitter and receiver is paired ID, can pair each other automatically while turning on the devices. Blue indicator light after connection.
- Long press button 2 seconds, blue indicator goes out, the device is turned off.
Charging and low battery instruction:
- When connect charger, green indicator will light, means battery is under charging status. The green indicator will go out after battery charging completely.
- When the battery is low, the green indicator light will light and blink slowly to alarm. At this time, the battery can maintain normal work around 30 minutes.
Paring operation
- Long press the button of transmitter 2 seconds till the device on, do not lose the button, keep long press the button 3 seconds, the green indicator blinks quickly, the paring set starts, blue indicator blinks quickly and enters paring waiting set.
- Long press the button of receiver 2 seconds till the device on, do not lose the button, keep long press the button 3 seconds, the green indicator blinks quickly, the paring set starts, blue indicator blinks quickly and enters paring waiting set.
- When pair successfully, the blue indicator light up.
- When 1 transmitter pairs with many receivers, only need to turn off the paired receivers, then repeat the paring operation steps for the unpaired receiver and transmitter.
NOTE: When the paring waiting starts, paring operation should be finished within the blue indicator blinks quickly 1 O cycles, otherwise, the pairing status will be quit automatically.
Package
- Earphone receiver x7
- Transmitter x7
- 3.5mm Audio cable x1
- USB Charge cable x7
- Manual x1
Specification
- Model name: K1
- Earphone type: Neckband Earphone
- Transmission mode: 5.8G
- MIC directivity: Omni-directional
- Barrier-free transmission distance: Around 30m
- Frequency response: 20Hz-20KHz
- SNR: -95dB
- Working duration: around 5 hours
- Charge time: around 2 hours
- Battery capacity: 650mA
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
As the product is constantly improving , these won’t be any further notice for
the improvement.
Actual product will not be as pictured , please make the object as the
standard.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>