TayMac MX6200 CUS Extra Duty Metal Weatherproof Use Cover User Manual

: May 15, 2024
: TayMac

Table of Contents

MX6200 CUS Extra Duty Metal Weatherproof Use Cover
CONFIGURING THE BASE
INSTALL UNIT
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Metal WIU, Extra Duty, 2 Gang,
Multi Device, W/Rain Chamber

MX6200 CUS Extra Duty Metal Weatherproof Use Cover

REVISIONS

REV.	DATE	DESCRIPTION	BY:
–	3/2/2020	INITIAL RELEASE	TCY

55 in 1
CONFIGURATIONS

TayMac MX6200 CUS Extra Duty Metal Weatherproof Use Cover - Parts
1

NOTES:

ALL DIMENSIONS ARE IN INCHES AND [MILLIMETERS]
cULus LISTED

MACHINE SCREW	STEEL	ZINC COATED
GASKET	PE FOAM	GRAY
ADAPTER	PLASTIC	GRAY
COVER	ALUMINUM	GRAY
BASE	ALUMINUM	GRAY
DESCRIPTION	MATERIAL	FINISH

LIST OF PARTS

THE DESIGN AND DIMENSIONS OF THE PRODUCT SHOWN ON THIS DRAWING ARE SUBJECT TO CHANGE WITHOUT NOTICE

TOLERANCE UNLESS OTHERWISE SPECIFIED
.XX DECIMAL ±.015
.XXX DECIMAL ±.005
ANGLE ±2°

DRAWN BY:| TCY| SCALE:
1:5| SIZE: A
---|---|---|---
APP. BY:| N.S.
DATE:| 3/2/2020

CONFIGURING THE BASE

Duplex

Comes pre-configured with duplex adapter installed.

GFCI

For GFCI, remove duplex adapter from back.	GFC ready.

Toggle Switches / Round Receptacles

For toggle/round devices, break out both round pieces, and center piece using pliers.| Use the appropriate adapter. For rounds, use pliers toincrementally snap off rings until desired circumference is achieved.
Snap adapter onto back of base.
---|---

INSTALL UNIT

TayMac MX6200 CUS Extra Duty Metal Weatherproof Use Cover -
Diagram

IMPORTANT: Tum off power to receptacle at the circuit breaker box or equivalent. Configure base as shown on other side. Back out mounting screws. Do not remove screws. (Note: Make sure that box is flush or slightly behind the finished surface and that receptacle is flush with the finished surface in accordance with NEC 406.4 and 314.20.) Align keyholes on base with screws and slide to the left. Tighten screws until snug (avoid overtightening).

NOTE: Base should be installed on a smooth flat surface. To ensure a weatherproof seal on irregular surfaces such as brick or cedar siding, a 1/4 inch bead of non-hardening silicone caulk (not included) must be placed between the gasket and the mounting surface

WARNING: improper installation of any electrical device can cause serious injury or death.
CAUTION: Device must protrude through the base or duplex/round adapters. If not, please use UL approved spacers (not included) to move the device forward in the box.