EOYUTLLY LX-058 Two Door Cabinet Installation Guide
- May 15, 2024
- EOYUTLLY
Table of Contents
Installation Guide
Two Door Cabinet
LX-058 Two Door Cabinet
Anything,please feel free to contact us.
E-mail: service20197@hotmail.com
Before You Start
Read through each step carefully and follow the proper order
Separate and count all your parts and hardware
Give yourself enough room for the assembly process
Alave the following tools: Flat Head Screwdriver, #2 Phillips Head
Screwdriver and Hammer
Caution: If using a power drill or power screwdriver for screwing,
“please be aware of to slow down and stop when screw is tight.
Failure to do so may result in stripping the screw.
Helpful Hints
PEOPLE NEEDED FOR ASSEMBLY: 1-2
– Open your item in the area you plan to keep it to avoid excessive heavy
lifting.
– Identify, sort and count the parts before attempting assembly.
– Compression dowels are lightly tapped in with a hammer.
– Slides are labeled with an R (right) and L (left) for proper placement.
– Make sure to always face the point on the top of the Cam Lock towards the
outer edge.
– Use all the nails provided for the back panel and spread them out equally.
– Back panel must be used to make sure your unit is sturdy.
– Do NOT use harsh chemicals or abrasive cleaners on this item.
– Never push, pull, or drag your furniture.
| | | | | |
---|---|---|---|---|---|---
EXPLODED DRAWING:
PARTS: 
REMARK: 
|
---|---
|
|
WARNING
ANTI – TIPPING DEVICE
WALL ANCHORING GUIDE
- Using anti-tipping device to attach your furniture to the cavity wall of furniture and your wall material.
- The hardware you should use to secure your furniture to the wall depends on both your type
TYPE
OF WALL MATERIAL
- Mark the attachment point(s) with a pencil at the appropriate height.
- Use the following guide to identify your wall material and choose the corresponding steps.
| Drywall or plaster with available wood stud
D 4/8-inch (3mm) diameter pilot hole(s) into the wood stud(s), at the height
you marked with pencil.
---|---
| Drywall without available wood stud
Drill 27/64-inch (10.5mm) diameter hole (s) through the wall at the height you
marked with pencil.
Drive the plastic plug(s) into the hole(s), using a hammer if needed.
| Masonry
Drill 27/64-inch (10.5mm) diameter hole(s) 2-inches (50mm) deep into the wall
at the height you marked with pencil.
Drive the plastic plug(s) into the hole(s), using a hammer if needed.
If your wall material is not listed here, or if you have any questions,
consult your local hardware store.
Follow the appropriate pictogram instructions below, drive the screw(s) with
washer(s) through the brackets and tighten screw(s) firmly into the plastic
plug(s) in the wall. Do not over-tighten. 
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>