OBZ M60 Mini 2D Bluetooth Barcode Scanner User Guide
- May 15, 2024
- OBZ
Table of Contents
OBZ Mini 2D Bluetooth Barcode Scanner
Model: M60
Connection Instructions
Bluetooth Connection
Step 1: (Choose 1 from 2 of the following methods)
Method 1: Press and hold the button for 8 seconds until the scanner blue
light flashing, it enters pairing state.
Method 2: Scan below pairing code I and code II in sequence , the scanner
blue light flashing, it enters pairing state.
|
---|---
**X=0102**|
**X=0101** Bluetooth Pairing Codes
Step 2:
Open Bluetooth on the mobile device and search for “R&B40” and click
pairing. The scanner blue light is always on, indicating that pairing is
complete.
NOTE:
- After long press button or scanning the pairing codes enter pairing state, please complete the pairing within one minute. If the pairing is not completed in one minute, you need to long press button or scanning the pairing codes again for pairing.
- At a same time only one device can be connected. If you need to connect to another Bluetooth device, please turn off the Bluetooth of the original device first and unplug the USB Receiver.
2.4Ghz USB Dongle Connection
Step 1: (Choose 1 from 2 of the following methods)
Method 1: Press and hold the button for 8 seconds until the scanner blue
light flashing, it enters pairing state.
Method 2 : Scan below pairing code I and code II in sequence, the scanner
blue light flashing, it enters pairing state.
|
---|---
**X=0100**| X=0103
USB Dongle Pairing Codes
Step 2:
Then plug the USB receiver into the computer USB port, the scanner blue light
is always on, indicating that pairing is complete.
NOTE:
- After long press button or scanning the pairing codes enter pairing state, please insert USB receiver into computer within one minute. If the pairing is not completed in one minute, you need to long press button or scanning the pairing codes again for pairing.
- At a same time only one device can be connected. If you need to connect to another Bluetooth device, please turn off the Bluetooth of the original device first and unplug the USB Receiver.