RIAB 230428 Wood Iron Steel Bench Instruction Manual

: June 17, 2024
: RIAB

Table of Contents

RIAB 230428 Wood Iron Steel Bench
USE INSTRUCTIONS
CONTENT
SETUP
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

RIAB 230428 Wood Iron Steel Bench

INTENDED USE
The bench is intended exclusively for indoor use as a seat. The maximum load capacity of the bench is 3 people with a respective body weight of up to 100 kg.

USE INSTRUCTIONS

Please read carefully before first use, keep for later use!

Safety instructions:

Inspect the bench for damage or wear before each use.
Do not use the product if damage is visible or suspected.
The bench must only be used for its intended purpose.
The bench is not designed for any other use.
Improper use may result in injuries to the user.
Only place the bench on solid, level ground. Ensure stability.
On slippery floors, the bench must be secured against slipping.
Avoid high loads at certain points.
Pointed and angular objects can cause slight dents and scratches on the seat.
As soon as visible damage occurs, check the bench for safe standing before further use.
Do not use near open flames or heat sources (e.g. radiant heaters, ovens).
Do not smoke on or near the bench.

Contact with liquid:

The bench must not be placed in rooms with constant high humidity.
If it comes into contact with water, wipe it off with a dry cloth and let the bench dry completely before using it again.
If the bench has been in contact with liquids for a long period of time, it can lose stability. Cleaning instructions:
Only use dry or damp, soft cotton cloths.
Do not use cleaning agents.

Please note:

Due to the manufacturing process, paper-cut edges may be sharp.
Assemble the bench carefully to minimize the risk of injury.

Storage Instructions:

The bench can only be stored flat in its packaging when dry.
The bench must be stored in a dry place and protected from external weather conditions.
The bench has an expected useful life of 5 years.

CONTENT

PLEASE NOTE:
The corrugated board has two sides. The side with the smaller flutes should always be on the outer-side. The side with the larger flutes is inside. The cut edges of corruga-ted cardboard can be sharp. When assembling the furniture, run a blunt object over all edges to minimize the risk of cuts.

Prefold all parts once at the creased points.

SETUP

Place the centre layer (C) and the inner envelope (B) in the outer envelope (A).
Now insert the large tabs of the legs (D) on the left and right into the recess in the middle position (C). The interlocking tabs connect the components (D) to the center layer (C) and close component B in on itself.
Insert the cross-connectors (E) into the tabs provided on one side of the outer envelope (A) and fold it over.
Now fold the second side of the outer cover (A) inward and tuck in the flaps. Proceed carefully and evenly over the entire length. Please note: The plug-in connection is very tight, but this gives the bench the necessary stability.
Fold component (D) inward using the creases as shown.
Insert the two small flaps of the legs (D) into the outer cover (A) and secure the leg with the connector (F).
Turn the bench with the seat facing upwards onto the feet.