CHAMPION 201214 7500W Dual Fuel Electric Start Generator User Guide

CHAMPION 201214 7500W Dual Fuel Electric Start Generator

PARTS INCLUDED

Safety Information

DANGER

MOVE GENERATOR OUTDOORS

Using a generator indoors CAN KILL YOU IN MINUTES. Generator exhaust contains carbon monoxide. This is a poison you cannot see or smell.

NEVER use inside a home or garage, EVEN IF doors and windows are open. ONLY use OUTSIDE and far away from windows, doors, and vents.

WARNING

Read the ENTIRE operator’s manual to become familiar with the features of this product before operation. This QuickStart Guide IS NOT a substitute for the Operator’s Manual.

Failure to operate the product correctly could result in damage to the product, personal property or cause serious injury or death.

NOTICE

Keep all objects at least 5 feet (1.5 m) from generator. Heat from the muffler and exhaust gas can ignite combustible materials.

SET UP

1. Attach wheel kit.   Assembly > Install Wheel Kit
   

2. Connect the battery. Assembly > Connect the Battery.
   

3. Add oil. Assembly > Add Engine Oil.
   

4. Move the generator outdoors.
   ONLY USE OUTSIDE AND FAR AWAY FROM WINDOWS, DOORS, AND VENTS.
   

START UP

5. Add fuel – Gasoline or Propane (LPG)
   Assembly > Add Fuel
   FOR GASOLINE OPERATION: DO NOT USE E15 OR E85
   

6. DO NOT plug in any electrical devices.
   NEVER START OR STOP THE GENERATOR WITH
   ELECTRICAL DEVICES CONNECTED OR TURNED ON!
   

7. Select Fuel. Operation > Starting the Engine.
   Gasoline: Turn fuel select dial to “GASOLINE RUN” position.
   Propane: Turn fuel select dial to “PROPANE RUN” position.
   

8. Move the choke lever to the “CHOKE” position.
   

9. a. Starting the Engine: Gasoline
   Electric Start

10. Press and hold the ignition switch to the “START” position.

11. Move the choke lever to the “RUN” position.
    
    Manual Start

12. Pull the starter cord.

13. Move the choke lever to the “RUN” position.
    
    Starting the Engine: Propane (LPG)
    Electric Start

14. Open the propane tank valve.

15. Press the ignition switch to the “START” position for 2-3 seconds.

16. Move the choke lever to the “RUN” position.

17. Press and hold the ignition switch to the “START” position.

18. If engine does not start, wait 10 seconds, then repeat step 4.
    
    Manual Start

19. Open the propane tank valve.

20. Pull the starter cord 2-3 times until you feel some combustion pulses.

21. Move the choke lever to the “RUN” position.

22. Pull the starter cord.
    

23. Plug in. Operation > Connecting Electrical Loads.
    

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>