Autkors A8834 Shower Head with 5 Jet User Guide
- June 17, 2024
- Autkors
Table of Contents
A8834 Shower Head with 5 Jet
User Guide
A8834 Shower Head with 5 Jet
Welcome
Thank you for purchasing Autkors product. To ensure optimum performance and
safety, please read these instructions carefully before operating the product.
It is strongly recommended you keep the manual for future reference.
Package Content
1 x Shower Head 1 x User Manual
Product Specification
| Head Diameter | 96.2mm |
|---|---|
| Height | 223.7mm |
| Weight | 150g |
| Material | ABS plastic and TPR soft glue |
| Technology | injection molding |
| Surface Treatment | chrome plating |
| Interface | G 1/2 |
Installation Guide
- Unscrew the existing shower head from the flexible shower hose.
- Be careful to retain the position of the hose washers at the junction.
- After connecting the hose to the shower, tighten the joint between the shower head and the hose. Do not screw too tightly.
- Hang the shower head in a fixed place, open the water and check whether the joint will leak.
- Turn the spray plate until it clicks once to select any of the five spray patterns.
Precautions
- Please carefully inspect there are no any signs of damage before installation.
- Please ensure there is no debris inside the shower hose and head before installation.
- While installing, please confirm the position of the hose washers at the connection, otherwise it will be loose and easy to leak after tightening.
- Tighten the nuts to prevent water leakage.
- . Please check again after installation. Especially pay attention to whether the connection is tight to avoid leakage in the future.
Washing instruction
- Regularly rub the silicone part of the nozzle and wipe it with a soft cloth to prevent water alkali accumulation.
- Regularly clean the spray plate with a mild detergent or soap solution and wipe with a soft cloth.
- In the case of serious water-alkali accumulation, you can dilute the vinegar and water in a ratio of 1 to 3. Soak one side of the shower panel into the mixture after diluting. (note: Simply immerse the part of the nozzle into the mixture. Do not soak the entire shower head in the mixture. After a period of time, take out the shower head and wipe it with clean water.
For any information or questions, please contact us with an email: support@autkors.com
Thank you for choosing Autkors products.
For any information or questions, please contact us:
TEL: 1-800-360-5881
EMAIL: support@autkors.com
WEBSITE: www.autkors.com
© Shenzhen Teng Xun Zhan Yi Technology Co., Ltd.
All rights reserved,
Product Name: Shower Head
Model: A8834
Manufacturer: Shenzhen Teng Xun Zhan Yi
Technology Co., Ltd.
Manufacturer Address: Room 302, Building 8, Yunli
Intelligent Park, Fada Road, Bantian Street, Longgang
District, Shenzhen, Guangdong, China