FENIX BC15R Lightweight Cut Off Facula Line Bicycle Light User Manual
- June 17, 2024
- FENIX
Table of Contents
FENIX BC15R Lightweight Cut Off Facula Line Bicycle Light
FEATURES
400 LUMENS MAX OUTPUT
31.5 HOURS MAX
RUNTIME
DIMENSIONS
WARNING
- DO place this light out of the reach of children!
- Do NOT shine the light directly into the eyes of anyone!
- Do NOT place light head near flammable objects, high temperatures can cause objects to overheat and become flammable/ignite!
- Do NOT use the light in inappropriate ways such as holding the unit in your mouth, doing so could cause serious personal injury or death if the light or internal battery fails!
- This light will accumulate a significant amount of heat while operating, resulting in a high temperature of the light shell. Pay close attention to avoid burns.
- Please turn off the light to prevent accidental activation during storage or transportation.
- The LED of this light is not replaceable; so the whole light will need to be replaced when the LED reaches the end of its lifespan.
FENIX BC15R BICYCLE LIGHT
- 400 lumens maximum output and 78 meters maximum beam distance.
- Built-in 2600mAh battery.
- USS Type-C charging.
- Easy and fast operation with a single switch.
- Battery level indication and low-voltage warning.
- Anti-glare cut-off facula line makes urban commuting safer for oncoming persons.
- Compatible with Fenix bicycle light helmet holder and bicycle light holder with GoPro interface.
- I P66 rated protection.
- Size: 4.02″ x 1.24″ x 1.22″/102 x 31.5 x 31 mm.
- Weight: 3.84 oz/109 g(including battery).
OPERATING INSTRUCTIONS
On/off
Press and hold the switch for 0.5 seconds to turn/off the light.
TECHNICAL PARAMETERS
|
HIGH
| MED|
LOW
|
FLASH
---|---|---|---|---
OUTPUT
|
400 lumens
|
150 lumens
|
50 lumens
|
400/50 lumens
RUNTIME| 3 hours 40 minutes*| 10 Hours 30 minutes|
31 hours 30 minutes
|
/
DISTANCE
| 78 meters| 47 meters| 28 meters| /
INTENSITY
|
1504 candela
|
549 candela
|
200 candela
|
/
IMPACT RESISTANCE
|
1 meter
WATERPROOF|
IP66
Note: The above specifications are the test results produced by Fenix
through its laboratory testing using the Fenix ARB-L 18-2600 battery under the
temperature of 21 +3°C and humidity of 50% – 80%.
The true performance of this product may vary according to different working
environments.
*The High output is measured in total of runtime including output at reduced levels due to the built-in temperature protection mechanism.
Output Selection
With the light switched on, single click the switch to cycle through Low → Med
→ High.
Flash Mode
With the light switched on, double click the switch to enter Flash mode,
single click again to exit Flash mode and return to the previously used mode.
Intelligent Memory Circuit
The bicycle light memorizes the last selected output excluding Flash mode.
When turned on again the previously used mode will be recalled.
CHARGING
- Switch off the light and open the autidust cap to reveal the USB Type-C charging port and plug the USB A socket of the charging cable into an electrical outlet, then connect the USB Type-C socket of the charging cable to the light.
- The indicator will display red while charging and will turn green when fully charged.
- 0nce charging is completed, be sure to close the autidust cap to maintain the dustproof and waterproof ability.
Note:
- The normal charging time of the light is approximately 2 hours from depletion to fully charged.
- Recharge a stored light every four months to maintain the optimum performance of the battery.
- The Low mode can be operated while charging but the charging time will be prolonged.
BATTERY LEVEL INDICATION
With the light switched off, single click the switch to check the battery
status, the indicator in the switch will last for 3 seconds.
Green light on: saturated 100% – 85%
Green light flashes: sufficient 85% – 50%
Red light on: poor 50% – 25%
Red light flashes: critical 25% – 1 %
INTELLIGENT OVERHEAT PROTECTION
The light will accumulate a lot of heat when used at relatively high modes for extended periods. Therefore it will automatically downshift to a lower brightness level to reduce the temperature to a safe level when this situation occurs. High mode can be reselected if needed.
LOW-VOLTAGE WARNING
When the voltage level drops below the preset level, the bicycle light is programmed to downshift to a lower brightness level until Low output is reached. When this happens in Low output, the battery level indicator constantly blinks red to remind you to recharge the battery till the battery level runs out.
USAGE AND MAINTENANCE
- Disassembling the sealed head can cause damage to the light and will void the warranty.
- Recharge the battery in time to ensure normal use for next time.
- Recharge a stored light every four months to maintain optimum performance of the battery.
- Once charging is completed, be sure to close the anti-dust cover.
INCLUDED
Fenix BC15R bicycle light, USS Type-C charging cable, User manual, Information leaflet, Warranty card
LIGHTING FOR EXTREMES
FACEBOOK
WECHA
“Follow” us for more information about Fenix.
Tel: +86-755-29631163/83/93 Fax: +86-755-29631181
E-mail: info@fenixlight.com Web:
www.fenixlight.com
Address: 2F/3F, West of Building A,
Xinghong Technology Park, 111 Shuiku Road,
Fenghuanggang Community,
Xixiang Street, Bao’an District,
Shenzhen City,
Guangdong Province, China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>