Bestway 58765 Pool Cleaning Robot Instructions

June 17, 2024
Bestway

Bestway 58765 Pool Cleaning Robot

Bestway-58765-Pool-Cleaning-Robot-PRODUCT

Product Information

Specifications

  • Model Number: 58765
  • Website : www.bestwaycorp.com
  • Adaptor Information: JOD-S-090200GS-2 (for European countries except UK), JOD-S-090200BS-2 (for UK)

Product Usage Instructions

Important Safety Instructions

  • Ensure to use the appliance only with the specified adaptors mentioned above. Users must have proper supervision and knowledge of safe usage.
  • Avoid using the appliance during freezing weather conditions.

Disposal
Electrical products should be recycled where facilities exist. Contact local authorities or retailers for recycling advice.

Assembly and Operation
No Light: Check if the switch is off or the battery is empty.

Troubleshooting

  • Problem: The robot cannot capture debris, or it moves slowly or does not move at all.
  • Probable Cause: Low battery, filled debris compartment, blocked debris screen, stuck or broken impeller.
  • Solution: Charge the robot, clean debris compartment or screen, and check and remove any blockage.

FAQ

Questions:
If you have any questions, problems, or missing parts, please visit the support section on our website at bestwaycorp.com/support.

IMPORTANT SAFETY INSTRUCTIONS

WARNING

  1. If instructions is missed, please contact Bestway or search it on the website: www.bestwaycorp.com.
  2. The appliance is only to be used with the adaptor (JOD-S-090200GS-2) and (JOD-S-090200BS-2). The adaptor (JOD-S-090200GS-2) is for European countries except the UK, and the (JOD-S-090200BS-2) is for the UK.
  3. Disconnect the pump from the supply mains before carrying out user maintenance such as cleaning the filter.
  4. Always disconnect the appliance from the supply before assembling, disassembling, or cleaning.
  5. Appliances can be used by persons with reduced physical, sensory, or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and if they understand the hazards involved.
  6. Pumps without indication that they are protected against the effect of freezing shall not be left outside during freezing weather conditions.
  7. This appliance shall not be used by children.
  8. Cleaning and User maintenance shall not be carried out by children.
  9. Children shall not play with the appliance.
  10. This appliance contains non-replaceable batteries.
  11. Pool Vacuum: 9.0Vd.c. 2.0A IPX8
  12. Adaptor (JOD-S-090200GS-2) and (JOD-S-090200BS-2)
  13. Input: 100-240V~50Hz/60Hz 0.5A Class II
  14. Output: 9.0Vd.c. 2.0A 18.0W

DISPOSAL

Electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your local authority or retailer for recycling advice.

ASSEMBLY AND OPERATION

  • The robot will stop during use in the following pool conditions:

    • The bottom of the pool is folded
    • The pool was installed on uneven, unlevel or bumpy ground
      If the bottom has a large amount of debris, it is recommended to empty the basket after 10 minutes of use to optimize the robot’s performance.
  • Use only the original external adaptor and provided charging cable.

  • Make sure the robot and the charger port are clean and dry before charging.

  • Make sure that the robot is turned off by sliding the switch to the OFF position before charging.

  • Fully charge the robot (about 5-6 hrs) before using it for the first time.

  • Power Indicator light:

    • No Light: Switch is off, or the battery is empty
    • Green Light: Robot is running
    • Blinking Green Light: The switch is on but the robot is out of the water
    • Blinking Red Light: Battery will be empty in 10 minutes.
  • When the robot starts charging, the indicator light will blink red. When the robot is fully charged, the indicator light will turn green.

  • To adjust the float length, release enough rope from the float to cover the depth of pool water plus about 0.5 m (19.7″).

  • If the float is too far to be retrieved by hand, use the provided hook. Place the hook on a telescopic pole (not included) and then use the hook to retrieve the float.

  • it’s advised to turn off the filtration system as water circulation in the pool may affect the robot’s movement pattern.

  • Remove the pool ladder, surface skimmer and other floating objects from the pool, as it may obstruct the movement of the robot’s float and, consequently, also the movement of the robot.

  • lf you are using a saltwater pool, make sure all salt is dissolved before placing the robot into the water.

MAINTENANCE AND STORAGE

  • The battery will lose charge during storage. Make sure to fully charge the robot before storage.
  • You must recharge the battery at least once every three months when it is not in use.
  • Unplug the external adaptor from the socket and then unplug the charging cable from the external adaptor and robot.
  • Detach accessories from the robot. lf necessary, rinse the robot and accessories with fresh water. DO NOT use detergent.
  • Ве sure to drain the water from the robot before storing it.
  • Use а damp cloth to clean and dry the robot and its accessories.
  • We strongly recommend disassembling the product during the off-season (winter months) and storing it in a dry place with a moderate temperature between 10ºC/50ºF and 38ºC/100ºF.
    NOTE : А higher storage temperature may reduce the battery life

TROUBLESHOOTING

Problem Probable Cause Solution

The robot cannot capture debris, or it moves slowly or does not move at all.

| Low battery.| Charge the robot.
The debris compartment is filled, or the debris screen is blocked.| Clean the debris compartment or the debris screen.
The impeller is stuck or broken.| For assistance, please visit the support section on our website, www.bestwaycorp.com.
The robot stops moving, but the swivel head is still rotating.| The debris compartment is filled, or the debris screen is blocked.| Clean the debris compartment or the debris screen.
The robot is jammed by debris on the bottom.| Check and remove any debris.

The swivel head does not work or cannot stop working.

| The swivel head is stuck.| Check and remove any debris that is trapped under the swivel head or the rotating robot head.
The swivel head fails to work.| For assistance, please visit the support section on our website, www.bestwaycorp.com.
The flapper is stuck.| Check and remove any debris that hinders the movement of the flalpper.
The robot works around the pool wall and cannot cover the whole pool.| The debris compartment is filled, or the filter is blocked.| Clean the debris compartment or the filter.
Improper locking adjustment position.| Follow Step 3 in the diagrams for proper locking adjuster position.

The robot fails to charge.

| The battery is damaged.| For assistance, please visit the support section on our website, www.bestwaycorp.com.
The charger is jammed by debris.| Check and clean any debris.
The adapter does not work.| For assistance, please visit the support section on our website, www.bestwaycorp.com.

WHAT INBOX

Bestway-58765-Pool-Cleaning-Robot-FIG- \(1\)

INSTALLATION

Bestway-58765-Pool-Cleaning-Robot-FIG- \(2\) Bestway-58765-Pool-Cleaning-Robot-FIG- \(3\) Bestway-58765-Pool-Cleaning-Robot-FIG- \(4\) Bestway-58765-Pool-Cleaning-Robot-FIG- \(5\) Bestway-58765-Pool-Cleaning-Robot-FIG- \(6\) Bestway-58765-Pool-Cleaning-Robot-FIG- \(7\) Bestway-58765-Pool-Cleaning-Robot-FIG- \(8\) Bestway-58765-Pool-Cleaning-Robot-FIG- \(9\)

CLEANING AND MAINTENANCE

Bestway-58765-Pool-Cleaning-Robot-FIG- \(10\) Bestway-58765-Pool-Cleaning-Robot-FIG- \(11\)

©2023 Bestway Inflatables & Material Corp.
All rights reserved/Tous droits réservés
Trademarks used in some countries under license from
Bestway Inflatables & Material Corp., Shanghai, China
Manufactured, distributed and represented in the European Union by
Bestway Europe S.p.a., Via Resistenza, 5, 20098 San Giuliano Milanese (Milano), Italy
Distributed in Latin America by
Bestway Central & South America Ltda, Salar Ascotan 1282, Parque Enea, Pudahuel, Santiago, Chile
Distributed in Australia & New Zealand by Bestway Australia Pty Ltd, Unit 2/98-104 Carnarvon St Silverwater, NSW 2128, Australia
Tel: Australia: (+61) 2 9037 1388; New Zealand: 0800 142 101
Distributed in the United Kingdom by Bestway Corp UK Ltd. 8 Wentworth Road, Heathfield Industrial Estate, Newton Abbot, Devon, TQ12 6TL
Exported by Bestway (Hong Kong) International Ltd./Bestway Enterprise Company Limited
Suite 713, 7/Floor, East Wing, Tsim Sha Tsui Centre, 66 Mody Road, Kowloon, Hong Kong
www.bestwaycorp.com
bestwaycorp.com/support

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals