Loa Keo LLC LK2IN1 Portable PA Karaoke and Livestream System User Manual
- June 17, 2024
- Loa Keo LLC
Table of Contents
LK2IN1 Portable PA Karaoke and Livestream System
INSTRUCTION MANUAL
Portable PA Karaoke & Livestream System Model:LK2in1
DEAR CUSTOMER
In order to achieve the best performance of your product,please read this
instruction manual carefully before using,and keep it for future reference.
IMPORTANT SAFETY INSTRUCTIONS
For all products
- Read these instructions.
- Keep these instructions.
- Heed all warnings.
- Follow all instructions.
- D0 not use this apparatus near water.
- Do not block any ventilation openings. Install this apparatus in accordance with the manufacturer’s instructions
- Do not install this apparatus near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.
- Do not defeat the safety purpose of the polarized or grounding- type plug. A polarized plug has two blades with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
- Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles and the point where they exit from the apparatus.
- Use only attachments/accessories specified by the manufacturer.
- Unplug this apparatus during lightning storms or when unused for long periods of time.
- To disconnect this apparatus from the AC mains completely, disconnect the power- supply cord plug from the AC receptacle.
- Use only with the cart, stand, tripod, bracket or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
- The mains plug of the power-supply cord shall remain readily operable.
- D0 not expose batteries to excessive heat such as sunshine, Fire or the like.
- This apparatus is intended to be used only with the power supply and/or charging cable provided by the manufacturer.
- Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power- supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, has been dropped, or is missing battery doors.
- CAUTION : Permanent hearing loss may occur if earphones or headphones are used at high volume for prolonged periods of time.
Note:To prevent possible hearing damage, do not listen to high volume
levels for long periods.
** The Lightning flash with arrowhead symbol, with an equilateral triangle
s intended to alertthe user of the presence of uninsulated dangerous voltage
within the product’s enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR
BACK). USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE
PERSONNE
** The exclamation point within an equilateral triangle is intended o alert
the user of the presence of important operating and maintenance (servicing)
instructions in the literature accompanying the appliance.
Federal Communication Commission Interference Statement
FCC AND IC INFORMATION FOR USERS
Caution FCC and IC statement for users (USA and Canada only)
This device complies with Part 15 of the FCC rules and Industry Canada
license-exempt
RSS standard(s). Operation is subject to the following two cond巾ons: (1) This
device may not cause harmful interfe「ence; and (2) this device must accept any
interference received, including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by LK Australia
could void the user’s authority to operate the equipment.
This product must not be disposed of or dumped with your other household
waste. You are liable to dispose of all your electronic or electrical waste
equipment by relocating over to the specified collection point for recycling
of such hazardous waste. Isolated collection and proper recovery of your
electronic and electrical waste equipment at the time of disposal will allow
us to help conserving natural resources. Moreover, proper recycling, and
collection points, please contact your local city center, household waste
disposal service, shop from where you purchased the equipment, or manufacturer
of the equipment.
Instructions for Users on Removal, Recycling and Disposal of Batteries
The remove the batteries from your equipment or remote control, reverse the
procedure described in the owner’s manual for inserting batteries. For
products with a built-in battery that lasts for the lifetime of the product,
removal may not be possible for the user. In this case, recycling or
recovery, it becomes necessary to replace such a battery; this procedure must
be performed by authorized services centers. In the European Union and other
locations, it is illegal to dispose of any battery with household trash. All
batteries must be disposed of in an environmentally sound manner. Contact your
local waste-management officials for information regarding the environmentally
sound collection, recycling and disposal of used batteries. ****
INTRODUCTION
Congratulations on your purchase! We encourage you to take a few minutes to
read this manual, which describes the product and includes step-by-step
instructions to help you to setup and get started. Read and understand all the
safety instructions before using your product.
If you have any questions about these products, their installation or their
operation, please contact your retailer or customer service, or visit us at
LKAUSTRALIA.COM.AU
WARNING:
Danger of explosion if battery is incorrectly replaced. To reduce risk of fire
or burns, don’t disassemble, crush, puncture, short external contact, expose
to temperature above 60°C (140°F), or dispose of in fire or water. Replace
only with specified batteries.
In case of batteries, accumulators and button cells containing more than
0.0005 mercury, more than 0.002% cadmium or more than 0.004% lead, shall be
marked with the chemical symbol for the metal concerned: Hg,Cd or Pb
respectively. Please Refer to the below symbol: Hg, Cd, Pb.
WARNING:
DO NOT INGEST BATTERIES, CHEMICAL BURN HAZARD [the remote supplied with] this
product contains a coin/ button cell battery. If the coin/button cell battery
is swallowed, it can cause severe international burns in just 2 hours and can
lead to death. Keep new and used batteries away from children. If you think
batteries might have been swallowed or placed inside any part of body, seek
immediate medical attention.
WHAT’’S IN THE BOX
Product code: LK2IN1
Peak Power: 600W
Battery capacity: Power lithium battery 7.4V/5Ah
Speaker unit: 6.5 inch bass1
Neodymium horn tweeter1
MIC frenquency: 520.0MHz-546.0MHz
ACCESSORIES
1. Adaptor1
2. Remote1
3. Audio cables2
4. Approved US/Australia AC Adapter and power plug1
CONTROL PANEL
1. Power on or off.
2.Increase or decrease the volume level
3. Treble:
4 Bass
5. Echo
6. Treble (MIC)
7.Bass (MIC;(M)
8. Volume (MIC)
9. Total Volume:
10. Battery level indicator.
11.DCI5VIN
12: GUITAR – Connect to the guitar
13.TFCARD
14.USB- Connect to a USB storage device.
15. Live — 3.5mm Audio Out (Livestream to fb live, youtube live, audio or
video recording)
16. ACCO – Accompaniment Input (3.5mm Audio Input)| 17: MONITOR- Earphone
connection
18: MIC.OUT
19: MIC IN – Connect to a microphone.
20: HEADSET
21: LED Display
22. MODE:
23: REC: Recording/ Play the recording
24: Previous Song
26: Next song
25: Play, pause or resume.
27: REPEAT
28: Voice Fx
29: Sound Fx
30: Vocal RVM
31: MIC. PRI
32: Coaxial Input
33: EXTDC12VIN
---|---
REMOTE CONTROL
1.REPEAT
2. MUTE
3.0~9 Choose the songs
4. Karaoke
5. INPUT
6.VOL+
7.VOL-
8. Previous Song
9. Play/Pause
10. Next song
11. Voice broadcast ON/OFF
12. Delete Recording| 13. M.MENU : MIC MENU
14. Recording
15. RC.PY: Recording Play
16. M.VOL+
17.M.VOL-
18. SES: Special Effect sound: ApplauseE
19. M.PRI: MIC Priority
20.RESET
21. DEL VOCAL: Delete Vocal
22. Vocal
23.U/TF: USB/TF
---|---
CHARGING
LK2IN1 is powered by a built-in rechargeable battery.
Always connect the system to an earthed outlet.
IMPORT ANT:
- Fully charge the built-in battery before using for the first time, which will prolong the battery lifespan.
- Charge the battery before and after each use
- Similar to a car battery – Charge the built-in battery at least every 30 days.
- Always switch off the device if not in use
- Disconnect AC Power plug when it s fully charge.
- Deep discharging or over-charging of battery must be avoided to ensure sufficient life-time and sometimes also the operation safety of these batteries
- Built-in battery charging works on AC power only.
Charge your Speaker
Use the AC power to charge your LK2INT.
- Make sure that the speaker is turned off
- Connect the AC Power adapter(supplier) to the speaker first before turn on the mains power at the wall socket
- Indicator lights up in BLUE while charging
- Indictor lignts up in GREEN when the battery is fully charged
USING YOUR LK2IN1
Bluetooth Connection
You can use your LK2IN1 as an external speaker for your Bluetooth enabled
smartphone or tablet
- Press Mode to enter Bluetooth pairing mode.
- Choose “LKAustralia” or “LK2IN1″ to connect
- 0nce successfully connected, audio will stream from your Bluetooth device to this speaker
To terminate the Bluetooth-enabled device:
- Turn off this speaker;
- Disable Bluetooth on your device; or
- Move this speaker beyond the Bluetooth operational range.
To reconnect the Bluetooth-enabled device
- When you turn on this speaker next time, it tries to reconnect the last connected device automatically;
- If not, manually select “LKAUSTRALIA” Or “LK2IN1” on your Bluetooth device to start a connection.
USB Connection / Recording
With your LK2IN1, you can enjoy music that is stored on a USB storage device
such as an MP3 player.
Plug your USB storage device into the USB port of your LK2IN1. The music will
play automatically. If not, please check if the USB device contains playable
audio contents
AUX Connection
To play music on your portable audio device through this speaker, make sure
that no Bluetooth connection or USB device is available.
1.Connect a 3.5mm audio cable to:
- the headphone socket of your portable audio device;
- the AUX connector of this speaker
Turn on your portable audio device and it starts playing
Recommended Karaoke Settings
Livestream
Connection
Livestream must be in Bluetooth mode or Line in Mode
TROUBLESHOOTINGS
Caution
-Never try to repair the product by yourself. If you have any problems while using this product, check the following points before you request service
System
The unit will not turn on
- Check if the power cord is plugged into the outlet and to the LK2IN1
- For “LK2IN1″ make sure the speaker is fully charged, if not use the power cord to turn on your speaker.
Sound
No sound from the LK2IN1.
- Make sure that the LK2IN1 is powered on.
- Make sure that volume level is turned to an audible level
- Make sure that it is connected to a music source.
Bluetooth
A device cannot connect with the LK2IN1.
- Check if you enable the Bluetooth function of the device.
- The LK2IN1 is already connected to another Bluetooth device. Press and hold on Bluetooth to disconnect and pair with a new device.
Poor audio quality from a connected Bluetooth device
- The Bluetooth reception is poor. Move the device closer to the LK2IN1, or remove any obstacle between the device and the LK2IN1.
Product name | LK2IN1 |
---|---|
AC power input | 100-240V~50/60Hz 3.0A Max |
Built-in battery | lithium battery 7.4V/5Ah |
USB output | 5V 2.1A |
Speaker drivers | 6.5 inch bass |
Neodymium horn tweeter1
Speaker impedance| 4 ohm
Peak output power| 600 W
Microphone Frequency Complies with new FCC rules| V5.0
Bluetooth version| 520.0MHz-546.0MHz
USB format| FAT16, FAT32
USB file format| .mp3, .wma, .wav
Dimension (W x H x D)| 7.5kgs
Net weight| 420mm298mm*370mm
Scan For SupportVideoshttps://lkaustralia.com.au/help/ Brand:LK Love Karaoke
Purspose of Goods:Active Portable Speaker
Manufacturer:Love Karaoke Australia, 29 Disraeli Street, St Albans,
Victoria 3021 Australia
Country of Origin:China
Warranty Period:1 yearhttps://lkaustralia.com.au/terms-conditions/
USA Sales & Support:650-999-0420
Information about service center:https://lkaustralia.com.au
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>