indem automation MX3 Control Board Roller Shutters Instruction Manual
- June 17, 2024
- indem automation
Table of Contents
MX3
Control board for roller shutters and awnings automation
MX3 Control Board Roller Shutters
Caratteristiche tecniche
| Power supply | 220V |
|---|---|
| Power consumption | 250W |
| Memory storage | 20 remotes |
| Frequency | 433 Mhz |
| Range | 200m open field |
35m through 3 walls
Dimensions| 50 x 50 x 25 mm
Wiring
Is possible to connect indipendent buttons for Up – Stop – Down commands.
Once the Up or Down command is given, the motor will move automacally unless
it reaches its limitswitch.
An additional command during the opening or closing will Stop.
UDC command are dry contacts, do not put 220V here.
Indem MX3 control unit supports MURANO, MUNO and MS3 radio devices.
**** This product falls within the scope of Directive 2012/19/EU concerning
the management of waste from electrical and electrostatic equipment (WEEE).
The appliance must not be powered with household waste as it is made up of
various materials that can be recycled in suitable facilities. Inquire through
the municipal authority regarding the location of the ecological platforms
suitable for receiving the product for disposal and its subsequent correct
recycling.
Please also remember that upon purchase of an equivalent device, the
distributor is required to collect the product to be disposed of free of
charge as long as it is transported to its logistics office. The product is
not potentially dangerous for human and environmental health, as it does not
contain harmful substances, but if abandoned in the environment it has a
negative impact on the ecosystem. Read the instructions carefully before using
the appliance for the first time. It is recommended that you absolutely do not
use the product for a purpose other than that for which it was intended, as
there is a risk of electric shock and mechanical trauma if used improperly.
The crossed out bin symbol on the label on the appliance indicates compliance
with the WEEE legislation. Abandonment in the environment and illegal disposal
are punishable by law.
Programming 1st radio device
There are two different ways to add a radio device, one for the first (directly on the board) and the other one from the second and so on, by using a remote already paired.
- P2 button is present both on MURANO (on the back, where the battery is) and MS3 detector.
On MUNOs it’s equivalent to press at the same time both UP and STOP.
** If right after programming it works in reverse, that is when press UP the shutter goes down and viceversa, do the programming again and press DOWN in the last step.
*** Is possible to enter in program mode also by pressing quickly 4 times DOWN button wired on D-C contacts, this function is particularly usefull if it’s hard to access to the MX3 control board.
Programming additional devices
To be done nearby the control unit using a remote already paired.
Total radio reset
To be done nearby the control unit using a remote already paired.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>