Beionxii A398SP-1PK Outdoor Solar Post Lights Instruction Manual
- June 17, 2024
- Beionxii
Table of Contents
SOLAR POST LAMP
Models: A398SP-1PK / A398SP-1PK/B
PLEASE READ THE INSTRUCTION MANUAL CAREFULLY TO OBTAIN THE BEST RESULTS FROM YOUR PURCHASE.
PRE-INSTALLATION GUIDELINES
- For optimum light duration throughout the night, it is very important to mount your solar light in a spot where it receives maximum amount of sunlight throughout the day. 4-6 hours of direct sun exposure is the ideal condition.
- It may take couple of days for the light to be charged and work properly.
- If you are replacing an existing gas/electric post light, you must consult a certified technician to cancel them before installation.
REMOTE CONTROL INSTRUCTIONS
TURN ON/OFF
ON: Press this button to turn on the light and activate dusk to dawn
mode.
OFF: Press this button to turn off the light and enter sleep mode.
3 COLOR TEMPERATURE
WW: Press this button to set a warm white light.
NW: Press this button to set a neutral white light.
CW: Press this button to set a cool white light.
Note: A brief flicker of the light indicates successful setup.
BRIGHTNESS ADJUSTMENT
+: Increase the brightness by 10% each press.
-: Decrease the brightness by 10% each press.
Note: The light blinking 3 times to indicate maximum/minimum brightness.
20%: Press this button to set the brightness to 20%.
50%: Press this button to set the brightness to 50%.
TIMER
3H: Press this button to automatically turn off the light after 3 hours.
5H: Press this button to automatically turn off the light after 5 hours.
8H: Press this button to automatically turn off the light after 8 hours.
ASSEMBLY INSTRUCTIONS
SUPPORT 2 MOUNTING WAYS:
- FOR POST MOUNT: Place the solar post lamp on top of your existing 3″ round post and tighten the 3 screws provided to secure the lamp.
- FOR PIER MOUNT: Place the solar post lamp on the flat suface of the pier/pillar and tighten the base with the 4 screws provided to secure the lamp base.
NOTE: Model A398SP-1PK does not come with pier mount base.
MAINTENANCE AND TROUBLE SHOOTING
MAINTENANCE:
Clean the solar module regularly with a damp towel to guarantee optimum
performance of the solar panel. Do not use any type of solvent for cleaning
and be careful not to put too much pressure on the module while cleaning.
TROUBLE SHOOTING:
If your solar charged light does not come on at dusk despite observance of all
the instructions, please try the following steps:
- Make sure that the solar light is not being affected by any other light source (i.e street lights).
- Ensure the solar light is not positioned in the shade during the day.
- Make sure the remote is “ON”.
- Check that the batteries are installed correctly.
NOTE: The performance of the solar light will vary with the time of year. It will deliver longer duration when it has had a full day in the sun rather than a day in overcast weather.