CMD Chip Desk 4A Twin Port USB Charger User Guide
- June 4, 2024
- CMD
Table of Contents
CMD Chip Desk 4A Twin Port USB Charger
Connecting to power
Connecting standard 3-pole connector
- Plug the male 3-pole connector supplied as standard into a female powered connector.
- Ensure the attached locking mechanism clicks into place on both connectors.
Disconnecting standard 3-pole connector
- Use a suitable tool to release the locking mechanism.
- Separate the connectors.
USB charging
- Insert the USB type A connector from your device into a port on the Chip.
- Ensure the cable is securely connected. The ports on the Chip output 2A each.
Mounting to desk
- Offer the Chip with the included C-clamp upto the intended furniture location
- Ensure the inside face of the C-clamp butts up against the edge of the desk as shown.
- Tighten the fixing bolt so the Chip is secure in place and does not move.
- The Chip is now secured in place and ready to connect to a power source.
Additional information
Safety
- Installation is to be carried out in accordance with relevant Health & Safety regulations and only to be carried out by a skilled or competent person.
- The product should be installed to comply with the relevant national standards and be inspected and tested prior to being put into service (in the UK BS 7671 Wiring Regulations or BS 6396 Office and Educational Systems Best Practice).
- Isolate the supply before installation or repositioning. Any locking mechanisms must be used and fully engaged.
- Incorrect use could lead to risk of electrocution.
- Product to be used only for the intended purpose of distributing power in office and commercial environments.
- Do not misuse, dismantle or re-configure the product because doing so will invalidate the warranty.
Standards
Refer to the Declaration of Conformity
Further guidanc
Should the supply cable need replacing, contact CMD
Product care
- Clean using a dry cloth. No abrasives or solvents to be used on the product.
- Do not drop or expose to moi
Part No: 134259 Issue No: 001
CMD Ltd, Rotherham, S65 1EN, UK
T: 01709 829 511 E: enquiries@cmd-ltd.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>