TCHELICON Voicetone Harmony-G Xt User Guide
- June 7, 2024
- TCHELICON
Table of Contents
Quick Start Guide VOICETONE HARMONY-G XT
(1) Input knob
Adjust the input gain so that the adjacent LED lights green while you sing,
and occasionally lights orange during the loudest peaks.
(2) Tone button
A single press activates or deactivates AdaptiveTone to make your voice
smoother and brighter, indicated by a solid LED when engaged. A double click
activates or deactivates auto-chromatic pitch correction to provide subtle
pitch support, indicated by a periodic flash of the LED when engaged. When
both effects are engaged, the LED will light solid except for periodically
flashing off.
(3) Guitar knob
Controls the guitar volume when the THRU jack is not used. The far left Auto’ position automatically balanced your guitar volume with your voice. Just above theAuto’ setting is an `Off’ setting that mutes the guitar.
(4) FX knob
Adjusts the mix level of the effect selected with the FX button.
(5) Harmony knob
Adjusts the mix level of the harmony and double effects.
(6) Preset button
Press to cycle through the 5 presets shown in the display. Hold the Preset
button to save changes made to the current preset.
(7) 48V LED
Hold the Manual and Double buttons for 2 seconds to engage phantom power for
use with condenser microphones.
(8) Manual button
Press to allow the guitar signal to dictate the harmonies. Details of this
function are discussed in the full manual.
(9) Double button
Press to simulate the sound of two of you singing in unison.
(10) Voice 1/2 buttons
Press either of the Voice buttons to select a harmony interval. Details of
this function are discussed in the full manual. Hold both buttons to select
stereo or mono operation.
(11) FX button
Press to cycle through the available effect styles for the current preset.
When no LEDs are lit, the effects are bypassed.
(12) Preset A/B footswitch
Tapping the footswitch will toggle between the presets assigned to slot A and
B. Hold the footswitch to enter Preset Select mode for the current slot (A or
B), which allows the footswitch to cycle through all 5 saved presets.
(13) On/Bypass footswitch
Tapping the footswitch engages or disengages the doubling and harmony effects
in the current preset, leaving the reverb/delay effects active. Holding the
footswitch will enter Tuner/Bypass mode, which mutes the guitar signal and
bypasses all vocal effects except for Tone.
(14) USB port
Connect to a computer for firmware updates and support.
(15) Power input
Connect the included power adapter. (12 V DC, 300 mA, tip negative)
(16) OUTPUTS
Connect to a mixer via XLR cables.
(17) INST IN/THRU
Connect your guitar to the IN jack, then connect the THRU to other guitar
pedals or an amplifier.
(18) MIC INPUT
Connect your microphone via XLR cable.
(19) GND
If you hear a buzz when you plug in a cable from the THRU to your amp or PA,
press this button in. If the THRU jack is not used and your guitar sound is
routed internally, the Ground Lift switch should be left out.
Visit tc-helicon.com to download the full manual
LEGAL DISCLAIMER
Music Tribe accepts no liability for any loss which may be suffered by any person who relies either wholly or in part upon any description, photograph, or statement contained herein. Technical specifications, appearances and other information are subject to change without notice. All trademarks are the property of their respective owners. Midas, Klark Teknik, Lab Gruppen, Lake, Tannoy, Turbosound, TC Electronic, TC Helicon, Behringer, Bugera and Coolaudio are trademarks or registered trademarks of Music Tribe Global Brands Ltd. © Music Tribe Global Brands Ltd. 2019 All rights reserved.
LIMITED WARRANTY
For the applicable warranty terms and conditions and additional information regarding Music Tribe’s Limited Warranty, please see complete details online at musictribe.com/warranty.
Zhongshan Eurotec Electronics Limited
No. 10 Wanmei Road, South China Modern Chinese Medicine Park, Nanlang Town,
528451, Zhongshan City, Guangdong Province, China
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>