tweak Enhance HS-TE4-BEIGE Hearing Aids User Guide

quick start guide

box contents

charging information

1. Plug the type-C USB connector into the charging base.

2. Plug the opposite end of the cable into the adapter block then connect with the power sour

3. The charging base is marked with blue and red circles. Place the amplifier in the corresponding port. it will shut off automatically when placed in the charger. The rocker switch will glow blue while charging. When fully charged, the rocker switch will glow green.

Fully charge Tweak Enhance before proceeding to setup.

green light on base– normal operation| red light on base– fault in the instrument, base, cable, or adapter
Call 1-888-815-3240 for assistance.

preparing for use

1. Choose either a left or right sound tube.

2. Attach the tube connector end to the sound post on amplifier. Twist the tube clockwise until snug.
   

3. Choose tip to use with the sound tube.
   

4. Align tip with end of sound tube and push tip straight on.

wearing tweak enhance

1. Place Tweak Enhance over your ear. The curve of the sound tube should rest on top of your ear comfortably, even with glasses.

2. Grab the loose end of the tubing and gently insert the tip into the ear canal.

3. Position the retaining lock in the bowl of the ear.

4. When properly inserted, the tubing will lay close to the head around the front of the ear and into the ear canal. Check this by moving your finger down the tubing, into the ear.

Now you are ready to install the Tweak Enhance app on your phone and set up your devices.

https://tweakhearing.com/tweak-enhance-download/

Refer to the APP GUIDE inside the user manual to set up the Enhance devices using the Tweak Enhance app. The app can be downloaded at the App Store or Google Play Store. Scan the QR card at left for a shortcut to accessing the app.

using tweak enhance

Turning ON and OFF

To turn ON or OFF, press and hold the upper portion of the rocker switch until you hear a beep (approx. 3 seconds) then release. While you are holding the rocker switch, it will turn green. The green light will turn off once the amplifier is ON.
To turn OFF, press and hold the upper portion of the rocker switch until you hear a beep (approx. 3 seconds) then release. While you are holding the rocker switch, it will turn blue. The blue light will turn off once the amplifier is OFF.

Volume Control
The rocker switch is used as a volume control. Pressing the upper portion of the rocker switch increases the volume, while the lower portion reduces the volume.

As you increase/decrease the volume, you will hear beep sounds for each sound level.

Level 1| Level 2| Level 3| Level 4
MAX Volume
---|---|---|---
Beep| Beep| Beep| 2 Beeps
Level 1| Level 2| Level 3| Level 4
MAX Volume
Beep| Beep| Beep| 2 Beeps

Memory Switch
When the hearing instrument is turned ON, it will revert to the last program and volume setting.
To switch programs, press and hold the lower portion of the rocker switch for two seconds then release. Do the same to switch to the other programs.

tweaktweakhearing.com
TW ENHN QSG 0521 Rev A
1-888-815-3240

References

• OTC Hearing Aids | Tweak Hearing | Never Miss A Moment Again

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>