DUAL XD5220 AM FM CD Receiver Detach Face Owner’s Manual

INSTALLATION/OWNER’S MANUAL
AM/FM/CD Receiver with Detach Face
XD5220

Preparation

Please read entire manual before installation.
Before You Start

• Disconnect negative battery terminal. Consult a qualified technician for instructions.
• Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration.

Getting Started

• Remove 2 transit screws located on top of the unit.
• Insert the supplied keys into the slots as shown, and slide the unit out of the mounting sleeve.
• Install mounting sleeve into opening, bending tabs to secure.
• Connect wiring harness and antenna. Consult a qualified technician if you are unsure.
• Certain vehicles may require an installation kit and/or wiring harness adapter (sold separately).
• Test for correct operation and slide into mounting sleeve to secure.
• Snap trim ring into place.

TYPICAL FRONT-LOAD DIN MOUNTING METHOD

Wiring Diagram

• CAUTION – Do not attach any speaker leads to ground as severe damage will occur.

Control Locations

General Operation

Faceplate Removal| Press RELEASE and pull away from the left side to remove.
To re-install, insert right side of faceplate first then push left side to secure.
---|---
Semi-permanent
Faceplate Installation| Remove trim ring and install supplied #1 x 7/32” Phillips head screw through left side  of mounting frame into faceplate.
Power On/Off| Press PWR or any other button (except eject) to turn the unit on. Inserting a disc will  turn the unit on automatically. Press PWR to turn the unit off.
CD Mode| Insert a CD or press to begin or resume playback.
Tuner Mode| Press PWR or BAND to begin or resume tuner operation.
Bass Boost| Press BASS to activate and deactivate bass boost curve.
Activating this feature will enhance the bass frequencies when listening to music at all volumes.
Volume| Adjust volume using VOL▼ /▲ VOL s (00-46).
Mute| Press MUTE to silence the audio. “MUTE” will appear in the display. Press MUTE again to cancel.
Display| Press DISP to display the clock. The radio frequency (tuner mode) or CD  track/elapsed time (CD player mode) show by default.
Set the Clock| Press DISP to display the clock, then release. Press and hold DISP for 2 seconds, the  clock will begin to flash. Press TUNE << to adjust the hours and TUNE >> to adjust  the minutes.
Clock settings will be saved after 5 seconds.
12/24-hour Clock| The clock will display 12-hour AM/PM time in U.S. frequency spacing mode (PM  10:00). In European frequency spacing mode, the clock will display 24-hour time (22:00).
Reset| Press and hold for more than 2 seconds to RESET the unit upon initial installation.  The RESET button is located behind the faceplate. Refer to page 2 for details.
Audio| Press AUD to select between Volume (default), Bass, Treble, Balance & Fader.

Bass| Press AUD until BA appears
Press VOL ▼or ▲to adjust
( -7 minimum / 7 maximum)
Treble| Press AUD until TR appears
Press VOL ▼or ▲ to adjust
( -7 minimum / 7 maximum)
Balance| Press AUD until B appears
Press VOL ▼ (LEFT) or ▲(RIGHT) to adjust
(BL 15/BR 15) BAL 00 represents equal balance.
Fader| Press AUD until F appears
Press VOL ▼(FRONT) or ▼ (REAR) to adjust
(FF 15/FR 15) F 00 represents equal balance.

Tuner Operation

Seek Tuning| Press TUNE << or >> momentarily to seek the next strong
station.
---|---
Manual Tuning| Press TUNE << or >> for more than 2 seconds, then release.
“MANU” will momentarily appear in the display. Press TUNE << or >> momentarily to move radio frequency up or down one step at a time. Press and hold to advance  quickly. If tuning is not adjusted for 5 seconds, the unit will return to seek tuning  mode (default). “AUTO” will momentarily appear in the display.
Scan Tuning| Press SCAN to preview strong stations on the current band, pausing for 5 seconds at  each. Press SCAN again to cancel.
FM Local/Distance| Press LOC to activate local tuning for strong FM station reception only. Press LOC  again to cancel and resume distance tuning (default).
FM Mono/Stereo| Press MO/ST for more than 2 seconds during FM tuner operation to select mono or  stereo (default) reception of the broadcast signal.
Band| Press BAND to select between FM1, FM2, FM3 and AM1, AM2 bands.
Frequency Spacing| Press and hold BAND then press TUNE << to select European frequency spacing.  Press and hold BAND then press TUNE >> to select U.S. frequency spacing (default).  Anytime frequency spacing is changed, all station presets are erased.
Storing and Recalling
Station Presets| Up to 18 FM stations and 12 AM stations can be stored. To store a station, select the  desired band and station. Press and hold the desired preset button for more than 2  seconds. When stored, the preset number will appear in the display. The station can  be recalled anytime by pressing the corresponding preset button.
Automatically Store
Stations| Press AS/PS for more than 2 seconds to automatically store the six strongest stations  in the current band.
Preset Scan| Press AS/PS for less than 2 seconds to scan presets 1-6 on the current band, pausing  for 5 seconds at each. Press AS/PS again to cancel.

CD Player Operation

Insert CD| With the label facing up, insert a standard size CD into the CD slot. The CD will  automatically begin playback.
---|---
Eject CD| Press EJECT to eject the CD. The unit will change to tuner mode. If the disc is not  removed within 10 seconds, the unit will reload the disc. The unit does not have to  be turned on to eject CD.
Track Select| Press TRACK >> to skip to the beginning of the next track.
Press TRACK << to return to the beginning of the current track. Pressing TRACK << again skips to the beginning of the previous track.
Fast Forward and Reverse| Press and hold  TRACK >> or TRACK << to fast forward or reverse a track.
Pause| Press to temporarily stop CD playback.
Press again to resume playback.
Intro| Press INT to play the first 10 seconds of each track.
Press INT to cancel.
Repeat| Press RPT to continuously repeat selected track.
Press RPT to cancel.
Random| Press RDM to play all tracks in random order. Press RDM again to cancel. Random  mode is retained in memory when selecting between tuner, CD player and auxiliary  input modes and when the unit is turned on/off.
CD-R/CD-RW Compatibility| Some CD-Rs and CD-RWs may be incompatible with this unit, depending on media  type and recording method.

Limited One Year Warranty

This warranty gives you specific legal rights.
You may also have other rights which vary from state to state.
Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the original purchase. Dual Electronics Corp. agrees, at our option, during the warranty period,  to repair any defect in material or workmanship or to furnish an equal new, renewed or comparable product (whichever is deemed necessary) in exchange without charges, subject to verification of the defect or malfunction and proof of the date of purchase. Subsequent replacement products are warranted for the balance of the original warranty period.
Who is covered? This warranty is extended to the original retail purchaser for products purchased and used in the U.S.A.
What is covered? This warranty covers all defects in material and workmanship in this product. The following are not covered: installation/removal costs, damage resulting from accident, misuse, abuse, neglect, product modification, improper installation,  incorrect line voltage, unauthorized repair or failure to follow instructions supplied with the product, or damage occurring during return shipment of the product.

What to do?

1. Before you call for service, check the troubleshooting guide in your owner’s manual. A slight adjustment of any custom controls or connections discussed in your instruction booklet may save you a service call.
2. If you require service during the warranty period, you must carefully pack the product (preferably in the original package) and ship it by prepaid transportation with a copy of the original receipt from the retailer to an authorized service center.
3. Please describe your problem in writing and include your name, a return UPS shipping address (P.O. Box not acceptable), and a daytime phone number with your shipment.
4. For more information and for the location of the nearest authorized service center please contact us by one of the following methods:
   • Call us toll-free at 1-866-382-5476
   • Email us at cs@dualav.com
   Exclusion of Certain Damages: This warranty is exclusive and in lieu of any and all other warranties, expressed or implied, including without limitation the implied warranties of merchantability and fitness for a particular purpose and any obligation,  liability, right, claim or remedy in contract or tort, whether or not arising from the company’s negligence, actual or imputed. No person or representative is authorized to assume for the company any other liability in connection with the sale of this product.  In no event shall the company be liable for indirect, incidental or consequential damages.

Troubleshooting

Unit will not turn on
(no power)| Yellow wire not connected or incorrect voltage Red wire not connected or incorrect voltage| Check connections for proper voltage (11-16VDC)
Black wire not connected| Check connection to ground
Fuse blown| Replace fuse
Unit has power
(but no sound)| Speaker wires not connected| Check connections at speakers
One or more speaker wires touching each other or touching chassis ground| Insulate all bare speaker wires from each other and chassis ground
Unit blows fuses| Yellow or red wire touching chassis ground| Check for pinched wire
Speaker wires touching chassis ground| Check for pinched wire
Incorrect fuse rating| Use fuse with correct rating
Excessive skipping| Unit is not mounted correctly or backstrap is not secure| Check mounting sleeve and backstrap support
Physical defect in media (CD. CD-R or CD-RW)| Check media for scratches
Unit will not accept
a disc| CD mechanism position out of alignment| Press EJECT for 3 seconds to reset CD mechanism position
CD transit screws still in place| Remove 2 transit screws located on top of the unit.

Error Codes

RESET

Specifications

CD Player| Signal-to-noise:  >92dB
Frequency response:  10Hz-20kHz
Channel separation @ 1kHz:  >65dB
D/A converter:  1 Bit
---|---
FM Tuner| Tuning range:  87.5MHz-107.9MHz
Usable sensitivity:  8.5dBf
50dB quieting sensitivity:  10dBf
Stereo separation @ 1kHz:  40dB
Frequency response:  30Hz-13kHz
AM Tuner| Tuning range:  530kHz-1710kHz
Usable sensitivity:  22uV
Frequency response:  30Hz-2.2kHz
General| Total power output: 120 Watts Peak
Power output:  30Wx4 @ 4 ohm, 14.4 VDC
Operating voltage:  11-16 VDC, negative ground
Speaker output impedance:  4~8 ohms
Line output voltage:  2 Volts
Dimensions:  7″ x 7″ x 2″ (178 x 178 x 51 mm)

Design and specifications subject to change without notice.

Dual Electronics Corp.
21318 64th Ave. South
Kent, WA 98032
Toll Free: 1-866-382-5476
www.dualav.com
©2005 Dual Electronics Corp.
NSA0805-V01

References

• Premium Audio for Car, Marine, & Home - Dual Electronics
• Manual-Hub.com – Free PDF manuals!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>