DUAL XD5110 CD Receiver Owner’s Manual

: June 17, 2024
: Dual

Table of Contents

Preparation
Installation
Wiring Diagram
Control Locations
General Operation
Tuner Operation
CD Player Operation
Limited One-Year Warranty
Specifications
Troubleshooting
Documents / Resources

XD5110
INSTALLATION/OWNERS MANUAL
AM/FM/CD Receiver DUAL XD5110 CD Receiver

Preparation

Please read entire manual before installation.
Before You Start

Disconnect negative battery terminal. (consult a qualified technician for instructions)
Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration.

Getting Started

Remove 2 transit screws located on top of the unit.
Remove trim ring by pulling up gently in the center.
Insert the supplied keys into the slots as shown, and slide the unit out of the mounting sleeve.
Install mounting sleeve into opening, bending tabs to secure.
Connect wiring harness and antenna. (consult a qualified technician if you are unsure)
Certain vehicles may require an installation kit and/or wiring harness adapter (sold separately).
Test for correct operation and slide into mounting sleeve to secure.
Snap trim ring into place.

Installation

DUAL XD5110 CD Receiver - Installation

Wiring Diagram

DUAL XD5110 CD Receiver - Diagram

FUSES
When replacing fuses, make sure new fuse is the correct type and amperage.
Using an incorrect fuse could damage the radio.
The XD5110 uses one 1 amp AGC fuse (Ignition) and one 5 amp AGC fuse (Battery) located in-line.

CAUTION – Do not attach any speaker leads to ground as severe damage will occur.

Control Locations

DUAL XD5110 CD Receiver - Control Locations

1 Power
2 Volume
3 Track Up/Down
4 Eject
5 Band
6 Display
7 Local/Distance/CD Repeat| 8 Play/Pause
9 Bass Boost/CD Random
10 Mono/Stereo/CD Intro
11 Reset
12 Audio
13 Tuning
---|---

General Operation

Power On/Off| Press PWR to turn the unit on. Inserting a CD will turn the unit on automatically. Press PWR to turn the unit off.
---|---
CD Mode| Insert a CD or press to begin or resume playback.
Tuner Mode| Press PWR or BAND to begin or resume tuner operation.
Bass Boost| Press BASS to activate and deactivate bass boost curve. Activating this feature will enhance the bass
frequencies when listening to music at low volumes.
Volume| Adjust volume using VOL ▲ or VOL▼ (0-63).
Display| Press DISP to display the clock. The radio frequency (tuner mode) or CD track/elapsed time (CD player mode) show by default.
Set the Clock| Press and hold DISP until the clock begins to flash, then release. Press TRACK << to adjust the hours and TRACK >> to adjust the minutes. Press DISP momentarily to save the selected time.
Reset| Press and hold for more than 2 seconds to RESET the unit upon initial installation or if abnormal opeartion occurs.
Audio| Press AUD to select between Volume (default), Bass, Treble, Balance & Fader.

Bass| Press AUD until BAS appears Press VOLUME ▼ or ▲ to adjust (7 maximum / -7 minimum)
Treble| Press AUD until TRE appears Press VOLUME ▼ or ▲ to adjust (7 maximum / -7 minimum)
Balance| Press AUD until BAL appears Press VOLUME ▼ (LEFT) or ▲ (RIGHT) to adjust (BA.L 10/BA.R 10) BAL 0 represents equal balance.
Fader| Press AUD until FAD appears Press VOLUME ▲ (FRONT) or ▼ (REAR) to adjust (FA.F 10/FA.R 10) FAD 0 represents equal fader.

Tuner Operation

Tuning	Tu rn TUNE knob to select desired station.
FM Mono/Stereo	Press MONO during FM tuner operation to select mono or stereo

(default) reception of the broadcast signal.
Local/Distance| Press LOC to activate local tuning for strong station reception only. Press LOC again to cancel and resume Distance tuning (default).
Band| Press BAND to select between FM and AM bands.

CD Player Operation

Insert CD| With the label facing up, insert a standard CD into the CD slot. The CD will automatically begin playback.
---|---
Eject CD| Press the EJECT button to stop and eject the CD. The unit will change to tuner mode. If the disc is not removed within 10 seconds, the unit will reload the disc.
Track Select| Press TRACK >> to skip to the beginning of the next track. Press TRACK << to return to the beginning of the current track. Pressing TRACK << again skips to the beginning of the previous track.
Fast Forward and Reverse| Press and hold TRACK << or TRACK >> to fast forward or reverse a track.
Pause| Press to temporarily stop CD playback.
Press again to resume playback.
Intro| Press INT to play the first 10 seconds of each track.
Press INT to cancel.
Repeat| Press RPT to continuously repeat selected track.
Press RPT to cancel.
Random| Press RDM for more than 2 seconds to play all tracks in random order. Press RDM again for more than 2 seconds to cancel.
CD-R/CD-RW Compatibility| Some CD-Rs and CD-RWs may be incompatible with this unit, depending on media type and recording method.

Limited One-Year Warranty

This warranty gives you specific legal rights. You may also have other rights which vary from state to state.
Namsung America Inc. warrants this product to the original purchaser to be free from defects in material and workmanship, under normal conditions, for a period of one year from the date of the original purchase.
Namsung America agrees, at our option, during the warranty period, to repair any defect in material or workmanship or to furnish an equal new or renewed product in exchange without charges, subject to verification of the defect or malfunction and proof of the date of purchase.
During the One-Year Warranty Period: For One Year from the date of purchase, your product will be replaced with a new, renewed or comparable product (whichever is deemed necessary) if it becomes defective or inoperative. This is done without charge to you.
Replacement products are warranted for the balance of the original warranty period.
Who is covered? This warranty is extended to the original retail purchaser for products purchased and used in the U.S.A., in the 48 contiguous states ONLY.
What is covered? This warranty covers all defects in material and workmanship in this product. The following are not covered:
installation/removal costs, damage resulting from accident, misuse, abuse, neglect, product modification, improper installation, incorrect line voltage, unauthorized repair or failure to follow instructions supplied with the product, or damage occurring during return shipment of the product.
What to do? If the product requires warranty service, you must prepay the initial shipping charges. DUAL will pay the return shipping charges if the product is returned to an address within the USA.
Namsung America Inc.
Attn: Returns Center
21318 64th Ave. South
Kent, WA 98032 U.S.A.
Toll Free: 1-866-626-7863
Exclusion of Certain Damages: This warranty is exclusive and in lieu of any and all other warranties, expressed or implied, including without limitation the implied warranties of merchantability and fitness for a particular purpose and any obligation, liability, right, claim or remedy in contract or tort, whether or not arising from the company’s negligence, actual or imputed. No person or representative is authorized to assume for the company any other liability in connection with the sale of this product. In no event shall the company be liable for indirect, incidental or consequential damages.

Specifications

CD Player| Signal-to-noise: >86dB
Frequency response: 20Hz-20kHz
Channel separation @ 1kHz: >65dB
D/A converter: 1 Bit
---|---
FM Tuner| Tuning range: 87.5MHz-107.9MHz
Usable sensitivity: 12dBf
50dB quieting sensitivity: 16dBf
Stereo separation @ 1kHz: 40dB
Frequency response: 30Hz-13kHz
AM Tuner| Tuning range: 530kHz-1720kHz
AM sensitivity: 30uV
Frequency response: 80Hz-2kHz
General| Total power output: 100 Watts Peak
Power output: 25Wx4 @ 4 ohms, 14.4 VDC
Operating voltage: 11-16 VDC, negative ground
Speaker output impedance: 4~8 ohms
Fuses: 1 amp fast blow AGC, 5 amp fast blow AGC
Dimensions: 7″ x 7″ x 2″ (178 x 178 x 51 mm)
Design and specifications subject to change without notice

Troubleshooting

Problem	Cause	Action
Unit will not turn on (no power)	Yellow or red wire not connected or
incorrect voltage	Check connections for proper voltage (11-16VDC)
Black wire not connected	Check connection to ground
Fuse blown	Replace fuse
Unit has power (but no sound)	Speaker wires not connected	Check connections

at speakers
One or more speaker wires touching each other or touching chassis
ground| Insulate all bare speaker wires from each other and chassis
ground
Unit blows fuses| Yellow or red wire touching chassis ground| Check for pinched wire
Speaker wires touching chassis ground| Check for pinched wire
Incorrect fuse rating| Use fuse with correct rating
Excessive skipping| Unit is not mounted correctly or backstrap is not secure| Check mounting sleeve and backstrap support
Physical defect in media (CD, CD-R or CD-RW)| Check media for scratches
Err appears on display| Load/Eject operation error| Press eject or RESET

Namsung America Inc.
21318 64th Ave. South
Kent, WA 98032
Toll Free: 1-866-626-7863
www.dualav.com
©2004 Namsung America, Inc.
EVOK0104-V02
https://manual-hub.com/