Magic Chef MCBC470BF 4.7 Cu.Ft. Beverage Cooler Instruction Manual

Magic Chef MCBC470BF 4.7 Cu.Ft. Beverage Cooler

NAMES OF THE PARTS

MODEL NO.: MCBC470BF

1. Thermostat Dial
2. Glass Shelves
3. Magnetic Gasket
4. Tempered Glass Door
5. Cabinet

SPECIFICATIONS

SPECIFICATIONS – Model # MCBC470BF

IMPORTANT SAFETY INSTRUCTIONS

WARNING: To reduce the risk of fire, electrical shock, or injury when using your appliance, follow these basic precautions:

• Read all instructions before using the beverage cooler.
• DANGER or WARNING: Risk of child entrapment.
• To avoid the possibility of child entrapment, please take the following precautions before throwing out the beverage cooler.
  • Remove all doors from the unit.
  • Leave the shelves in place so that children may not easily climb inside.
• Never allow children to operate, play with, or crawl inside the beverage cooler.
• Refrigerants: All refrigeration products contain refrigerants, which under the guidelines of federal law must be removed before disposal of the product. It is the consumer’s responsibility to comply with federal and local regulations when disposing of this product.
• Never clean beverage cooler parts with flammable fluids. The fumes can create a fire hazard or explosion.
• Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this or any other appliance. The fumes can create a fire hazard or an explosion.

INSTALLATION INSTRUCTIONS

Before Using Your Beverage Cooler

• Remove the exterior and interior packing.
• Before connecting the beverage cooler to the power source, let it stand upright for approximately 4 hours. This will reduce the possibility of a malfunction in the cooling system from improper handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth. (Cleaning instruction on page 7)

Installing Your Beverage Cooler

• This beverage cooler is designed to be free-standing only, and should not be recessed or built-in.
• Allow 5 inches of space between the back and sides of the beverage cooler, which allows the proper air ventilation. Adjust the feet to keep the beverage cooler level.
• Locate the beverage cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
• Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
• Ambient temperature below 55°F (12.8°C) or above 77°F (25°C) will hinder the performance of this appliance. This unit is not designed for use in a garage or any other outside installation.
• Avoid locating the beverage cooler in moist areas.
• Plug the beverage cooler into a dedicated, properly installed-grounded wall outlet.
• Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized service center.
• This unit is not designed to be installed in an RV or used with an inverter.
• After plugging the beverage cooler into a wall outlet, turn the unit on and allow the unit to cool down for 3 ~ 4 hours before placing beverages in the appliance.

Electrical Connection

WARNING

• Improper use of the grounded plug can result in the risk of electrical shock. \
• If the power cord is damaged, have it replaced by an authorized service center.
• This beverage cooler should be properly grounded for your safety. The power cord of this beverage cooler is equipped with a three-prong plug which mates with standard three-prong wall outlets to minimize the possibility of electrical shock.
• Do not, under any circumstances, cut or remove the third ground prong from the power cord supplied.
• This beverage cooler requires a standard 115 Volt A.C. /60Hz electrical outlet with three-prong ground.
• This beverage cooler is not designed to be used with an inverter.
• The cord should be secured behind the beverage cooler and not left exposed or dangling to prevent accidental injury.
• Never unplug the beverage cooler by pulling the power cord. Always grip the plug firmly and pull straight out from the receptacle.
• Do not use an extension cord with this appliance. If the power cord is too short, have a qualified electrician or service technician install an outlet near the appliance. The use of an extension cord can negatively affect the performance of the unit.
• If any problems with the beverage cooler persist, please contact our Customer Service Dept. to consult with a representative at 888 775-0202 or visit our website to request warranty service at www.mcappliance.com.

OPERATING YOUR APPLIANCE

Temperature Control

• Your beverage cooler has one control for regulating the temperature. The temperature control is located on the top center of the beverage cooler compartment.
• The first time you turn the unit on, adjust the temperature control knob to “7” and run for at least 2 hours before putting beverages inside. This will ensure the cabinet is thoroughly chilled before beverages is stored.
• The range of the beverage cooler temperature control is from position “1” the warmest to “7” the coldest. Adjust the temperature control to the setting that best suits your needs.
• To turn off the beverage cooler, please turn the temperature control knob to “0”. Please note that turning the temperature control knob to “0” position stops the cooling cycle, but does not disconnect the power supply to the beverage cooler.

WARNING: Do not set the temperature control to the setting of the “7” position for longer than 8 hours.

• If the unit is unplugged or loses power; you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the beverage cooler will not start.
• Changes in ambient temperature will affect the internal temperature of the beverage cooler.
• If you choose to change the thermostat setting, adjust the thermostat control by one increment at a time. Allow several hours for the temperature to stabilize between adjustments.

Changing The Interior Light

Before removing the interior light, turn off the beverage cooler first and then unplug the unit from the wall outlet. Failure to do so could result in electrical shock or personal injury.

• Use Phillips screwdriver to take out the screw holding the transparent light cover.
• Remove the transparent light cover gently.
• Pull out the existing light bulb by unscrewing it counterclockwise.
• Insert a new light bulb (E12, max. 15W) by screwing it in clockwise.
• Replace the transparent light cover and tighten the screw.

Automatic Defrost

• There is no need for manual defrosting of this beverage cooler due to the automatic defrosting function.
• The ice build-up on the inner back wall during compressor operation will be automatically defrosted once the compressor cycle is off.
• Defrost water will drain out passing through the drain outlet in the inner back wall into a drain pan located above the compressor, from where it evaporates.

CHANGING THE REVERSIBLE DOOR

This beverage cooler is built with a reversible door. You have the choice of either opening it from the left or the right side. To reverse the opening direction of your door, please follow these simple instructions.
Caution: To avoid personal injury to yourself and/or your property, we highly recommend that someone assist you during the door reversal process.

1. Remove the top hinge assembly and keep them for later use.
2. Remove the bottom hinge assembly and keep them for later use.
3. Remove the plug buttons from the upper left holes and transfer them to the uncovered holes on the right side. Be sure to press the plug buttons firmly into the hole.
4. Re-install the top hinge assembly previously removed in step 1 on the opposite side.
5. Re-install the bottom hinge assembly previously removed in step 2 on the opposite side.
6. Ensure that the door assembly is properly aligned with the cabinet before tightening the screws.

CARE AND MAINTENANCE

Cleaning Your Appliance

• Upon installation of your new appliance, it is recommended that it be cleaned thoroughly.
• Turn the temperature control knob to “0” and then unplug the unit from the wall outlet.
• Remove all contents.
• Wash the inside with a damp warm cloth soaked in lukewarm water and baking soda solution.
• The solution should be about 2 tablespoons of baking soda to a quart of water.
• Be sure to keep the door gasket (seal) clean to keep the unit running efficiently.
• The outside of the beverage cooler should be cleaned with mild detergent and warm water.
• Dry the interior and exterior with a soft cloth.

Vacation Time

• Turn the temperature control knob to “0” and then unplug the unit from the wall outlet.
• Remove all the contents.
• Clean the appliance.
• Leave the lid open slightly to avoid possible formation of condensation, mold, or odors.
• Short vacations: Leave the beverage cooler operating during vacations of less than three weeks.
• Long vacations: If the beverage cooler will not be used for several months, remove all content and unplug the power cord. Clean and dry the interior thoroughly. To prevent odor and mold growth, leave the door open slightly: blocking it open if necessary.

Moving Your Appliance

• Turn the temperature control knob to “0” and then unplug the unit from the wall outlet.
• Remove all the contents.
• Securely tape down all loose items inside your appliance.
• Tape the doors shut.

Energy Saving Tips

• The beverage cooler should be located in the coolest area of the room, away from heat-producing appliances or heating ducts, and out of direct sunlight.
• Ensure that the door is properly closed when the beverage cooler is turned on.

TROUBLESHOOTING GUIDE

You can solve many common beverage cooler problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling for service.

tripped or a blown fuse.
The temperature inside the beverage cooler is too warm.| Temperature control is set too warm. Turn the control to a cooler setting and allow several hours for the temperature to stabilize. The door is kept open too long or is opened too frequently. Warm air enters the beverage cooler every time the door is opened. Open the door less often. The door is not closed completely. The door gasket does not seal properly. The beverage cooler has recently been disconnected for a period of time. 4 hours are required for the beverage cooler to cool down completely.
The temperature inside the beverage cooler is too cold.| Temperature control is set too cold. Turn the control to a warmer setting and allow several hours for the temperature to stabilize.
Vibrations.| Check to ensure that the beverage cooler is on a level surface. The beverage cooler is touching the wall. Re-level the beverage cooler and move it from the wall. If continued vibration occurs, turn off the beverage cooler and unplug the power plug. Contact Customer Service Dept. for further assistance.
Moisture forms on inside beverage cooler walls.| The door is slightly open. The door is kept open too long or is opened too frequently. Open the door less often. The door is not sealed properly.
Moisture forms on the outside of the appliance.| The door is slightly open, causing cold air from inside the beverage cooler to meet warm moist air from outside.
The door will not close properly.| The beverage cooler is not on a level surface. The gasket is dirty.

Appliance Warranty

Unless otherwise prohibited, MC Appliance Corporation warrants each new appliance to be free from defects in material and workmanship and agrees to remedy any such defect or to furnish a new part(s) (at the company’s option) for any part(s) of the unit that has failed during the warranty period. Parts and labor expenses are covered on this unit for one year after the date of purchase. In addition, MC Appliance Corp. warrants the compressor (parts only) to be free from defects in material and workmanship for 5 years. The consumer is responsible for all labor and transportation expenses related to the diagnosis and replacement of the compressor after the initial one-year warranty expires. If if the unit is determined to be non-repairable under the terms of this warranty, the consumer is responsible for all transportation expenses to return the unit to our factory before receiving a refund. A copy of the dated sales receipt/invoice is required to receive warranty service or a refund.

This warranty covers appliances in use within the continental United States, Puerto Rico Hawaii, and Canada. The warranty does not cover the following:

• Damages due to shipping damage or improper installation.
• Damages due to misuse or abuse.
• Content losses due to failure of the unit.
• Inside components such as door panels, door shelves, racks, light bulbs, etc.
• Punctures to the evaporator system due to improper defrosting of the unit.
• Repairs performed by unauthorized service agents.
• Service calls that do not involve defects in material and workmanship such as instruction on the proper use of the product, door reversal, or improper installation.
• Replacement or resetting of house fuses or circuit breakers.
• Failure of this product if used for other than for its intended purpose.
• Disposal costs for any failed unit not returned to our factory.
• Any delivery costs incurred as the result of a unit that fails to perform as specified.
• Expenses for travel and transportation for product service if your appliance is located in a remote area where service by an authorized service technician is not available.
• The removal and reinstallation of your appliance if it is installed in an inaccessible location or is not installed by published installation instructions.
• Liability under this warranty is limited to repair, replacement or refund. If a replacement unit is not available or the unit cannot be repaired, liability is limited to the actual purchase price paid by the consumer.
• This warranty is non-transferable.
• This warranty applies only to the original purchaser and does not extend to any subsequent owner(s).

This warranty is instead of all warranties expressed or implied and no representative or person is authorized to assume for us any other liability in connection with the sale of this product. Under no circumstances is the consumer permitted to return this unit to the factory without prior written consent from MC Appliance Corporation.

• Model /Parts /Labor /Compressor /Type of Service /(part only)
  • MCBC470BF One-Year One-Year Five-Year In-Home

For Service or Assistance please call 888 775- 0202. Or visit us on the web at www.mcappliance.com to request warranty service.

• 4.7 CU.FT. BEVERAGE COOLER
• Model No.: MCBC470BF

To ensure proper use of this beverage cooler and your safety, please read the following instructions completely before operating this appliance.

Product Registration Copy

Thank you for purchasing a Magic Chef product. The first step in protecting your new product is to complete the product registration form on our website at www.mcappliance.com/register.The benefits of registering your product include the following.

1. Registering your product will allow us to contact you regarding a safety notification or product update.
2. If warranty service is required, registering your product will allow for more efficient warranty service processing.
3. In the event of an insurance loss registering your product could act as your proof of purchase.

Once again thank you for purchasing a Magic Chef product.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>