Beizhiyin TB39 Smart Watch User Manual
- June 17, 2024
- Beizhiyin
Table of Contents
Beizhiyin TB39 Smart Watch User Manual
Power on/off
Power on: At “OFF” state, press and hold the button for 3 seconds to turn on smart watch. (If failed, pls charge smart watch then power on again).
Power off: At “ON” state, press and hold the button for 3 seconds to turn off smart watch.
Download and install Bluetooth APP
The smart watch have to be connected by bluetooth with mobile phone.
Pls install Bluetooth APP on mobile phone before use.Then connect smart watch
and smart phone by bluetooth,smart watch data will be transmitted and
displayed on APP. Scan the below QR code to download and install the
corresponding app according to your phone.
How to connect smart watch to your smart phone by bluetooth?
There are two Bluetooth devices built-in smart watch, one named eWatch and the
other named eWatch audio.
To fully use Bluetooth function (message、 calling synchronization) of smart
watch, two Bluetooth devices need to be connected.
Connect the first Bluetooth: eWatch:
After downloading and installing APP, open it, search for devices, find
bluetooth name:eWatch, and connect; After connecting, the data on the watch
will be transferred to APP.
Connect the second Bluetooth:eWatch audio:
In the dial interface (Shown by Figure 1 ), slide down to enter the
notification bar (Figure 2), select the Bluetooth icon in the upper left
corner to open (Blue icon means open eWatch audio,grey icon means off eWatch
audio), shown by figure 2 :
Then turn on your phone’s Bluetooth, search for Bluetooth devices named eWatch audio to connect.After connecting, the sound from the phone can be transmitted to smart watch.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>