Kenmore 255.99782 Compact Refrigerator User Guide
- June 16, 2024
- Kenmore
Table of Contents
Use & Care Guide
Compact Refrigerator
4.4 cu. ft.
Compacto Refrigerador
4.4 cu. ft.
Models :
255.99782/255.99783
255.99789
PARTS AND FEATURES
- Freezer Compartment With Freezer Door
- Temperature control
- Drip Tray
- Wire Shelf
- Leveling Feet
- Package holder bar
- Pop can holder bar
- Bottle holder bar
SAVE THESE INSTRUCTIONS
DANGER
Risk of child entrapment . Before you throw away your old refrigerator, take
off the doors. Leave the shelves in place so that children may not easily
climb nside.
CFC/HCFC DISPOSAL
Your old refrigerator may have a cooling system that used CFCs or HCFCs
(chlorofluorocarbons or hydrochlorofluorocarbons). CFCs and HCFCs are believed
to harm stratospheric ozone if released to the atmosphere. Other refrigerants
may also cause harm to the environment if released to the atmosphere.
If you are throwing away your old refrigerator, make sure the refrigerant is
removed for proper disposal by a qualified technician. If you ntentionally
release refrigerant, you may be subject to fines and mprisonment under
provisions of environmental egislation.
WARNING: When handling, moving, using or cleaning this refrigerator, be
careful to avoid damaging refrigerant tubing. Tubing damage may allow
flammable refrigerant gas leakage, which can result n personal injury.
Thank you for using our l<enmore product. This easy-to-use manual will guide
you in getting the best use of your refrigerator.
PRODUCT RECORD
Staple your receipt to your manual.
Record the model and serial number of your unit in the spaces provided to the
right.
Model number:
255.99782/255.99783/255.99789
Serial number:
PREPARING TO USE YOUR REFRIGERATOR
Unpacking Your Refrigerator
- Remove all packaging material. This includes the foam base and all adhesive tape holding the refrigerator accessories inside and outside. Slide out and remove the plastic or foam guard used to protect the compressor from shipping damage due to vibration and shock.
- Inspect and remove any remaining packaging, tape or printed materials before powering on the refrigerator.
- Check to be sure you have all accessories and parts listed in the Parts and Features section.
Proper Air Circulation
To ensure that your refrigerator works at the maximum efficiency it was
designed for, you should install it in a location where there s proper air
circulation, plumbing and electrical connections.
The following are recommended clearances around the refrigerator:
Sides ……………………….3/4 inches (19mm)
Top ……………………..2 inches (50mm)
Back ………………….2 inches (50mm)
Electrical Requirements
Make sure there is a suitable power outlet (115 volts, 15 amps) with proper
grounding to power the refrigerator.
WARNING: Avoid the use of three prong adapters. NEVER cut off the third
grounding prong in order to accommodate a two prong outlet. Cutting off the
grounding prong is a dangerous practice since it provides no effective
grounding for the refrigerator and may result n serious njury from electrical
shock.
OPERATING YOUR REFRIGERATOR
Installation
Your refrigerator is designed for freestanding installation only. It should
not be recessed or built-in. Place the refrigerator on a floor strong enough
to support it fully loaded. When moving the refrigerator, never tilt it by
more than a 45 degrees angle. This could damage the compressor and the sealed
system.
If the refrigerator has been tilted more than 45 degrees, et it stand in an
upright position for at east 24 hours prior to plugging it into the power
source. This will allow the refrigerant to settle and reduce the possibility
of a malfunction in the cooling system.
Plug the refrigerator nto an exclusive, properly installed grounded wall
outlet.
Do not plug another appliance into the same outlet as the refrigerator.
Do not under any circumstances cut or remove the third (grounding) prong from
the power cord. See the WARNING in Electrical Requirements on the previous
page.
Any questions concerning power and/or grounding should be directed toward a
certified electrician or a Sears or other qualified service dealer.
After plugging the appliance into a wall outlet, allow the unit to cool down
for 2-3 hours before placing food into the refrigerator.
Installation Limitations
Do not install your refrigerator in any ocation not properly insulated or
heated, such as a qorcqe etc. Your refrigerator was not designed to operate in
temperature settings below 55° Fahrenheit. Select a suitable location for the
refrigerator on a hard even surface away from direct sunlight or heat sources
such as radiators, baseboard heaters, cooking appliances, etc.
Leveling Feet
There are two eveling feet on the bottom of the unit near the unit front.Turn
the eveling foot knobs to the left to raise the cabinet, and to the right to
lower the cabinet.
Door Reversal
WARNING: Unplug the refrigerator before performing door reversal process.
Failure to unplug may result in serious injury or death from electrical shock.
CAUTION: To avoid injury to yourself and/or property, we recommend
someone assist you during the door reversal process.
-
Using a flat blade screwdriver, remove the plastic hinge cover from the top of the door. Be careful not to scratch refrigerator surface.
-
Using a thin-bladed tool, carefully pry up and remove hole plugs from top of door andthe top of the opposite side of the cabinet; Insert plugs into provided hole on opposite side of door and into holes exposed by removal of top hinge bracket.
-
Using a slotted screwdriver, unscrew the two screws from the top hinge bracket. Remove the bracket and underlying paper gasket. Lift and remove the door from the bottom hinge pin. Set door safely aside.
-
Using a slotted screwdriver, remove the two screws attaching the bottom hinge bracket to the refrigerator cabinet. Unscrew the foot from the other side of cabinet.
Attach bracket and foot to opposite sides from which removed. -
Mount the door onto the bottom bracket. Be sure the plastic washer is on the bracket post. Insert top bracket hinge pin into hole in top of door. Use the two previously removed screws to attach back of top bracket to cabinet. Be sure to align the paper gasket beneath the two attachment holes in bracket.
-
Replace the plastic hinge cover over the top hinge bracket.
-
Check that the door is aligned horizontally and vertically and that the seals are closed on all sides before finally tightening the top hinge. Readjust the leveling foot. Turn clockwise to lower and counterclockwise to raise the level. CAUTION: If the refrigerator has been placed in a horizontal or tilted position for ease of door reversal, wait 24 hours before plugging it in. Plugging in sooner may result in permanent damage to cooling system.
Holder Bars
The inside of the refrigerator door is equipped with holder bars to keep
food packages, bottles and pop cans securely in place on the door shelves.
Initial Use
To reach the set coldness level when operating the refrigerator for the
first time, run it without food load until you hear the compressor stop. This
usually takes 2 to 3 hours. Once the set temperature is reached, load food
into the refrigerator.
Note: If the refrigerator has been placed in a horizontal or tilted
position for any period of time, wait 24 hours before plugging it in.
Temperature Control
The first time you turn the unit on, adjust the temperature control knob to
Recommended setting and give your refrigerator time to cool down completely
before adding food. After it is fully cooled, test it and adjust towards COLD
to make less cool or towards COLDEST to cool more to to best suit your needs.
Note: Turning the temperature control knob to the OFF position will stop the cooling cycle but does not shut off power to the unit.
Defrosting Your Refrigerator
For maximum energy efficiency , defrost the freezer section whenever frost
accumulates to a thickness of 1/ 8″ or more on freezer walls. Note that frost
tends to accumulate more during the summer months.
To defrost freezer section, open refrigerator door and door of freezer
compartment. Remove all food from refrigerator and food and ice cube tray from
freezer compartment. Place the drip tray on the shelf under the freezer
compartment. Turn the refrigerator temperature control dial to the OFF
position.
Defrosting may take several hours, so store food in another refrigerator in
the meantime.
To speed up defrost time, keep the door open and place a bowl of warm water in
the refrigerator.
During the defrost cycle, water will accumulate in the drip tray.
The drip tray may also need to be emptied during the defrost process.
After defrosting, empty and wipe down the drip tray, as well as the interior
of the refrigerator.
You may: now reset your refrigerator to the desired temoerature and return
food.
CAUTION: DO NOT use boiling water to melt frost accumulation on freezer
walls, as it may damage plastic parts.
WARNING: DO NOT use a sharp or metallic instrument to remove frost from
the refrigerator interior, as damage to refrigerant tubing may occur. Tubing
damage may allow flammable refrigerant gas leakage, which can result in
personal injury.
Normal Operating Sounds
You May Hear Boiling water, gurgling sounds or slight vibrations that are the
result of the refrigerant circulating through the cooling coils The thermostat
control will click when it cycles on and off.
CARE AND CLEANING
Cleaning and Maintenance
WARNING: To avoid electric shock, always unplug your refrigerator before
cleaning. Ignoring this warning may result in death or injury.
CAUTION: Before using cleaning products, always read and understand the
cleaning processes explained in this manual. Follow cleaning product
manufacturers’s instructions and warnings to avoid personal injury or product
damage.
General Cleaning
Prepare a cleaning solution of 1 to 2 tablespoons of baking soda mixed with
warm water. Use a sponge or soft cloth, dampened with the cleaning solution,
to wipe down your refrigerator.
Rinse with clean warm water and dry with a soft cloth.
Do not use harsh chemicals, abrasives, ammonia, chlorine bleach, concentrated
detergents, solvents or metal scouring pads.
Some of these chemicals may dissolve, damage and/or discolor your
refrigerator.
Door Gaskets
Clean door gaskets every three months according to the instructions described
above in General Cleaning.
Gaskets must be kept clean and pliable to ensure a proper seal.
Petroleum jelly applied ightly on the hinge side of gaskets will keep the
gaskets pliable and ensure a good seal.
Power Interruptions
Occasionally there may be power interruptions due to thunderstorms or other
causes. Remove the power cord plug from the AC outlet when a power outage
occurs. When power has been restored after a prolonged outage, nspect all food
for spoilage. Clean the inside of the refrigerator and freezer compartment
before reuse.
Vacation and Moving Care
For long vacations or absences, unplug the unit, empty food from both
compartments, move the temperature dial to the OFF position and clean the door
gaskets according to the General Cleaning section. Prop door open, so air can
circulate inside. When moving, always move the refrigerator vertically. Do
not move unit when in a horizontal position, as possible damage to the sealed
system could occur.
WARNING: When handling, moving, using or cleaning this refrigerator, be careful to avoid damaging refrigerant tubing. Tubing damage may allow flammable refrigerant gas leakage, which can result in personal injury.
TROUBLESHOOTING
Refrigerator does not operate| Check if the temperature control is in the Off
position.
Check if refrigerator is plugged in.
Check if there is power at the AC outlet by checking the circuitbreaker.
---|---
Food temperature appears too warm| Allow time for recently added warm food to
reach fresh food or freezer temperature.
Check gaskets for proper seal.
Adjust temperature control to colder setting.
Reduce the frequency of door openings.
Food temperature is too cold| If temperature control setting is too cold,
adjust to a warmer setting and allow several hours for temperature to adjust.
Refrigerator runs too frequently| This may be normal to maintain constant
temperature during high temperature and humid days.
Doors may have been opened frequently or for an extended period of time.
Check gasket for proper seal.
Check to see if doors are completely closed.
Moisture build-up on interior or exterior of the refrigerator| This is normal
during high humidity periods. Reduce prolonged or frequent door openings.
Check door gaskets for proper seal.
Refrigerator has an odor| Interior needs cleaning.
Foods improperly wrapped or sealed are giving off odors.
Refrigerator door does not shut properly| Level the refrigerator.
See Door Reversal section for description of door attachment features. Check
for blockages created by food containers, shelves, etc.
KENMORE LIMITED WARRANTY
FOR ONE YEAR from the date of sale this appliance is warranted against defects
in material or workmanship when it is installed, operated and maintained
according to all supplied instructions.
WITH PROOF OF SALE, return a defective product to the retailer from which it
was purchased for free repair or replacement at option of seller.
This warranty is void if this product is ever used for other than private
household purposes.
This warranty gives you specific legal rights, and you may also have other
rights which vary from state to state.
Sears Brands Management Corporation, Hoffman Estates, IL 60179
P/N 1347790008 (0807)
Sears Brands Management Corporation
Hoffman Estates, IL 60179 U.S.A.
www.kenmore.com
www.sears.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>