ONKYO SKS-3600 Speaker System Instruction Manual
- June 16, 2024
- ONKYO
Table of Contents
- Thank you
- Supplied accessories
- Placement
- Using the included cork spacers and installation brackets
- Connections
- Installation using commercially available stands and fixtures
- Precaution on use
- Speaker care
- Use with a TV set or computer
- Specifications
- Customer Support
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
ONKYO SKS-3600 Speaker System
Thank you
Thank you for your purchase of the Onkyo speaker system.
Please read this manual thoroughly before using it.
Following the instructions in this manual will enable you to obtain optimum
performance and listening enjoyment from your new speaker system.
Please retain this manual for future reference.
Supplied accessories
SKC-3600 (center speaker) × 1
SKM-3600 (surround speaker) × 2
Speaker cord × 3 (green: 3 m, blue, gray: 9 m)
Bracket × 4
Screw × 4
Cork spacer × 12
Placement
SKC-3600 (Center speaker)
Complements the sound effects from front left and right speakers to enrich and
clear the sound image and movement. In movies, an actor’s speech comes mainly
from the center speaker. Place the center speaker as close as possible to the
TV or monitor, pointing it towards the listener’s ears. Also, keep the center
speaker’s height at the same level as the front left and right speakers.
SKM-3600 (Surround left and right speakers)
Enhance the sensation of being at a live performance by giving three-
dimensional sound movement to the sound effects. Place the surround speakers
at the side of the listener or at a position diagonally from the listener.
Ideally, speakers should be placed symmetrically. Place these speakers so that
their height is 1 meter higher than that of the listener’s ears.
The speaker cabinet is made of wood and sensitive to extreme temperatures and
humidity. Avoid placing the speaker system in locations subjected to direct
sunlight or in humid places such as near an air conditioner, bathroom, or
kitchen.
Using the included cork spacers and installation brackets
We recommend that you use the included cork spacers so you can enjoy superior sound. The cork spacers also prevent the speakers from slipping.
Mounting on a wall
Wall-mount the speakers upside down. Layer two spacers and attach them to two
locations. The plaques rotate
so that you can position the speakers upside down.
Attaching the brackets:
Use the included screws to attach the brackets to the back of the speakers.
Caution:
- Make sure that the walls are rigid enough for supporting the speaker’s weight.
- The weight a mounting screw can support varies greatly depending on the wall material and the position of the reinforcing ribs embedded in the wall. Use the thickest and longest possible mounting screws whose head diameter is less than 10 mm and shank diameter is less than 4 mm (consult with your installer).
Connections
- Be sure to turn off your amplifier before connecting the speaker system. Connecting it while the amplifier is on may result in damage to the amplifier or the speaker system.
- The nominal impedance of this speaker system is 8Ω. Use only amplifiers capable of handling this impedance.
- Use the supplied speaker cables to connect between the speaker’s input terminals and the amplifier’s speaker terminals as illustrated below.
- Be sure to connect the Center, Surround Right and Left speakers with the amplifier’s corresponding speaker terminals. Also, be sure that you are connecting the speaker’s positive (+) and negative (–) input terminals with the amplifier’s corresponding positive and negative speaker terminals. Otherwise, undesirable sound field or impaired bass-range reproduction will result.
- Before turning on the amplifier’s power switch, pull lightly on the speaker cables to ensure that they are connected securely.
- To prevent damage to circuitry, never short-circuit the positive (+) and negative (–) speaker wire.
-
Strip the insulation of speaker cables, and twist the core wires tightly.
-
While pressing the lever, insert the wire into the hole, and then release the lever.
-
Make sure that the terminals are gripping the core wires, not the insulation.
Installation using commercially available stands and fixtures
The surround speaker bottom and rear are equipped with screw holes so that you
can attach commercially available stands or mounting fixtures for a variety of
mounting options. (Two M5 screw holes, 60 mm pitch on the bottom and one M5
screw hole on the rear.)
Note:
When attaching an accessory item to a speaker, be careful of the length of the
screws used. Use only screws that provide the required strength with a screw
length between 7 and 12 mm.
Precaution on use
- This speaker system can handle the specified input power when it is used for ordinary music reproduction. If the following abnormal signals are fed to the speaker, however, an overcurrent may flow in the internal circuits, causing burning or breakage of the wires even if the input power is below the specified rating.
- Noise produced when FM station is not tuned in
- Sound produced when fast-forwarding cassette tape deck
- High-frequency sound generated by an oscillator, an electronic musical instruments, etc.
- Oscillating amplifier signals
- Special test signals produced by audio checking CD, etc.
- Sound produced when connecting or disconnecting audio connection cables (Always turn off the amplifier’s power before connecting or disconnecting cables.)
- Howling when a microphone is used
- Do not place magnetic objects such as screwdrivers and iron parts near the speaker system since they use speakers with strong magnets. Otherwise, the objects may be attracted, causing injury or damaging the diaphragm.
Speaker care
Your Onkyo speakers are finished with a very high quality polymer laminate
covering that serves to protect the wood speaker cabinet.
The covering may be cleaned with a soft cloth moistened with water and a mild
soap. Avoid the use of furniture polishes or harsh cleansers.
Use a soft brush or hand vacuum cleaner to remove dust and lint from the
grille material.
Use with a TV set or computer
In general, Braun tubes used for color television sets and computers are
extremely sensitive and can be affected even by the magnetism of the earth. If
SKC3600 is used near them, therefore, discoloration or distortion of pictures
will occur. To allow use with a color television set or computer, this speaker
system is provided with magnetic shielding. Even so, discoloration may still
result, depending on the installation environment. If discoloration occurs,
turn off the power of the television set or computer, wait for 15 to 30
minutes and then turn it on again. This activates the self-demagnetizing
function of the television set or computer, improving the display condition.
Do not place SKM-3600 close to TV or a computer monitor because it has no
magnetic shield.
Note:
If discoloration persists even after performing this remedy, move the speaker
apart from the television set or computer. Discoloration may also be caused
when a magnet or other magnetizing object exists near the television or
computer because of the combined effect.
Specifications
SKS-3600
SKC-3600
Type: 2-way bass reflex
Impedance: 8 Ω
Maximum input power: 100 W
Output sound pressure level: 84 dB
Frequency response: 60 Hz – 35 kHz
Crossover frequency: 6000 Hz
Cabinet capacity: 2.3 L
Speaker (woofer): 8 cm cone × 2
Speaker (tweeter): 2.5 cm balanced dome
Dimensions: 310 (W) × 104 (H) × 127 (D) mm (Overall dimensions)
Weight: 2.1 kg
Others: Magnetic shielding
SKM-3600
Type: 2-way bass reflex
Impedance: 8 Ω
Maximum input power: 100 W
Output sound pressure level : 81 dB
Frequency response: 60 Hz – 35 kHz
Crossover frequency: 6000 Hz
Cabinet capacity: 1.2 L
Speaker (woofer ): 8 cm cone
Speaker (tweeter): 2.5 cm balanced dome
Dimensions: 104 (W) × 169 (H) × 127 (D) mm (Overall dimensions)
Weight: 1.1 kg
Specifications and appearance are subject to change for improvement without
prior notice.
In catalogs and on packaging, the letter added to the end of the product name
indicates the color of the SKS3600. Specifications and operation are the same
regardless of color.
Customer Support
ONKYO CORPORATION
Sales & Product Planning Div. : 2-1, Nisshin-cho, Neyagawa-shi, OSAKA
572-8540, JAPAN
Tel: 072-831-8023
Fax: 072-831-8124
ONKYO U.S.A. CORPORATION
18 Park Way, Upper Saddle River, N.J. 07458, U.S.A.
Tel: 201-785-2600 Fax:
201-785-2650 http://www.onkyousa.com
ONKYO EUROPE ELECTRONICS GmbH
Liegnitzerstrasse 6, 82194 Groebenzell, GERMANY
Tel: +49-8142-4401-0
Fax: +49-8142-4401-555 http://www.onkyo.net
ONKYO CHINA LIMITED
Units 2102-2107, Metroplaza Tower I, 223 Hing Fong Road, Kwai Chung,
N.T., HONG KONG Tel: 852-2429-3118 Fax: 852-2428-9039 SN 29343812A
(C) Copyright 2004 ONKYO CORPORATION Japan.
All rights reserved.
References
- AV Receivers, Stereo Receivers and Home Audio | Onkyo
- TOP | ONKYO
- Manual-Hub.com – Free PDF manuals!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>