SIMAGIC P1000 Pedal User Guide
- June 16, 2024
- SIMAGIC
Table of Contents
P1000 Pedal
User Guide
P1000 Pedal
List of accessories
| Fully-Threaded Bolt (M8-12)4 | Fully -Threaded Bolt (M8-16)4 |
|---|---|
| Pan Head Screw (M8-12)8 | Fully-Threaded Bolt (M6-12)6 |
| Roll in T-nut with Ball Spring (M6-40)6 | Flange Nut (M8)4 |
| Flat Head Socket Cap Screw (M5-10)6 | Red Spring’1 |
| Lubricating Grease*l | Yellow Spring1 |
| 5mm Allen Key with Rubber Handle1 | Cable Clip4 |
| Allen Key5 (2.5mm/3mm/4mm/5mm/6mm) | 1213mm Open spanner’ |
| {Pl000i additional accessories) Pan Head Screw(M5-16)6 | Flat Head Socket Cap |
Screw(M5-16)8
Overall installation instructions
2.1 Pl000 base assembly
2.1 Pl000i inverted platform Installation
2.2 Sim Rig installation
2.3 Installation for Customized Frames
2.4 Connection (USB and Independent Power Supply)
2.5 CAN-Bus and USB switching
Push the button to switch the pedal connection mode Switch to CAN-Bus mode
when the pedal is connected to the SI MAGIC Wheel Base (In CAN-Bus mode, the
indicator is blue)
Switch to USB mode when the pedal is connected to a PC (In USB mode, the
indicator is green)
Adjustments
3.1 Adjust the pedal face angle
3.2 Pedal Plate Height Adjustment
Loosen the two screws on the front of the pedal The pedal plate can be moved
up or down 
3.3 Heel Stop Adjustment
3.4 Adjust the Pedal Position (Left or Right) 
3.5 Travel adjustment (Bottom Limit Screws)
Loosen the two side screws then slide the limiter forward or backward to fine
tune the pedal travel
3.6 Throttle Strength Adjustment
The Throttle resistance can be adjusted by switching the installation hole
3.7 Clutch adjustment and spring replacement
3.7.1 Rotate the rear adjustable screw to fine tune the spring force
3.7.2 Replace the Clutch spring
- Loosen the rear adjustable screw
- Push the tail end forward and upwards to remove and replace the spring
3.8 Replacing the Brake Rubbers
- Loosen the jam nut on the back of the Brake, then spin the silver rod clockwise until completely loosened
- Lift up the brake cylinder and unscrew the red cap to access the rubbers (When disassembling and assem bling, note that the groove at the arrow is facing down)
Hardness: black -gray +blue-red (From soft to hard)
Note:
It is recommended to use no more than 8 Rubber Pads in the cylinder
Software & Applications
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>