Mintion UV Sensor for Resin 3D Printers User Guide
- June 16, 2024
- Mintion
Table of Contents
UV SENSOR
Quick Guide Manual
PACKING LIST
INTRODUCTION
NOTICE
This UV sensor is used to generate time-lapse videos for resin printers in
connection with the Mintion Beagle series cameras through Bluetooth. It cannot
be used independently without a Beagle series camera.
INSTALLATION
The example will be shown by using the Anycubic Photon Mono 4K 3d printer.
-
Power up the UV sensor, the LED will be solid illuminating.
-
Unscrew the screws on the base and insert the sensor through the fan hole.
-
Stick the UV cable to the house of 3d printer UV light and keep the sensor face to the screen. DO NOT insert the UV cable into the house of UV light, otherwise, it might cause the failure of printing.
-
Stick the cable to the base to prevent it fall when dragging.
Lock the screws on the base to check the installation is good.
-
Turn on the UV light in illumination on 3d printer and check if the Blue LED on UV sensor is fast flashing triple times.
Before adding the UV sensor to the Beagleprint app, and ensure the Bluetooth
firmware is upgraded to the latest version.
Hold the button on UV sensor for 3 seconds, the LED will be slow flashing, the
UV sensor is on matching status.
Click the UV sensor on the search result to add.
Select the UV Time-lapse Video mode on the camera setting page.
Input the model total layers on the page to ensure to have a completed time-
lapse video.
Click the print button on the resin 3d printer and observe the LED on UV
sensor is flashed in triple time when the first layer is projected.
www.mintion.net
SHENZHEN MINTION TECHNOLOGY CO., LTD
Distribution: sales@mintion.net
Support: support@mintion.net
FB Group: Mintion Official Group (Beagleprint)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>