Mology Z6 4MP Bulb Security Camera Instruction Manual

**Mology Z6 4MP Bulb Security Camera Instruction Manual

**

What’s in the Box

Bulb Camera

Bulb Base

Reset Pin

Operational Instruction

Warranty Card

PRODUCT OVERVIEW

Set up the Camera

STEP 1 Scan to download the Smart Life App from the App Store or Google Play store

STEP 2 Launch Smart Life App, register an account with a valid email address at the first use of Smart Life App, then log in.

STEP 3 Connect the camera to power via included bulb base.
Connect Power

STEP 4 Tap “Add DeviceTap Camera&Lock-Tap “Smart Camera (Wi-Fi)”

STEP 5 Hold on the Reset button for 5s until you hear a beep. Then Tap “Next”
Rest Camera

STEP 6 Enter password or tap to switch Wi-Fi and enter password-Tap “Next”

STEP 7 Place the QR code on your phone in front of the camera until you hear the “beep beep beep prompt. Tap “I Heard a Prompt”

STEP 8 Wait for the camera to connect until the connection is successful.

Install the Camera

Place the bulb camera into the position you want to install.

Specification

Troubleshooting

Failed to connect to WiFi during initial setup

• Ensure that you have entered the correct WiFi password.
• Put the camera closer to your router to ensure a strong WiFi signal.
• Change the encryption method of the WiFi network to WPA2-PSK/WPA-PSK. (safer encryption) on your router interface.
• Change your WiFi SSID or password and make sure that SSID is within 31 characters and password is within 64 characters.
• It is recommended that scan the QR code and connect to WiFi before installing it outdoors.

Failed to scan QR code on the phone

• Remove the protective film from the lens
• Wipe the camera lens with a dry paper/towel/tissue.
• Vary the distance between your camera and the mobile phone so that the camera can focus better.
• Try to scan the QR code under sufficient lighting or turn up the brightness of your phone to avoid the influence of sunlight or other sources of light.

If these won’t work, contact our support. support@mymology.com

Notification of Compliance

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Warning : Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

Notification of Compliance

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna,
• • Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.

Notification of Compliance

FCC RF warning statement:
The device has been evaluated to meet general RF exposure requirement, This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

Correct Disposal of This Product

This marking indicates that this product should not be disposed with other household wastes. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmentally safe recycling.

Notification of Compliance

Limited Warranty
This product comes with a 1-year limited warranty that is valid only if purchased from Mology Official Amazon Store or a Mology authorized reseller. (If you want to receive an additional 18 months warranty, please complete registration at our official website: https://mymology.com))

NOTE:
We hope that you enjoy the new purchase. But if you are not satisfied with the product and plan to return, we strongly suggest that you reset the camera to factory default settings and take out the inserted SD card before returning.

Terms and Privacy
Use of the product is subject to your agreement to the Terms of Service and Privacy Policy at reolink.com. Keep out of reach of children.

Notification of Compliance

End User License Agreement
By using the Product Software that is embedded on the Mology product, you agree to the terms of this End User License Agreement (“EULA”) between you and Mology.

Technical Support
If you need any technical help, please visit our official support site and contact our support team before returning the products

support@mymology.com
https://mymology.com

Shanghai Mojin Technology Co., Ltd.
support@mymology.com
https://mymology.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>