ITL UL 588 6FT Pre Lit Christmas Tree Owner’s Manual

June 16, 2024
ITL

TEST REPORT
UL 588
STANDARD FOR SAFETY
Seasonal and Holiday Decorative Products ITL UL 588 6FT Pre Lit Christmas
Tree - warranty

General disclaimer:
The test results presented in this report relate only to the object tested.
This report shall not be reproduced, except in full, without the written approval of the Issuing Testing Laboratory. The authenticity of this Test Report and its contents can be verified by contacting the Testing Laboratory, responsible for this Test Report.

ITL UL 588 6FT Pre Lit Christmas Tree - Signature

Copy of marking plate:
The artwork below may be only a draft. The use of certification marks on a product must be authorized by the respective NCBs that own these marks.

ITL UL 588 6FT Pre Lit Christmas Tree - Figure 1ITL UL 588 6FT Pre Lit Christmas Tree - Figure
2ITL UL 588 6FT Pre Lit Christmas Tree - Figure
3ITL UL 588 6FT Pre Lit Christmas Tree - Figure
4

General product information:
– The product is with a length of flexible cord assembled with an attachment plug for power-supply cord connection.
– The product is for indoor use and provided with manual.
– The product is a factory-assembled lighting assembly employing push-in lampholders connected in parallel across the line and neutral blades of the attachment plug or current tap.
– Adecorative lighting hamess is employed in a decorative outfit (Christmas tree) and it is provided with overcurrent protection.
– Model list

Fault Code Fault Reason Troubleshooting
E-2 Power supply
voltage range Check voltage range (24V: 18-32V, 12V: 9-16V), inspect the

battery or generator for normal operation, and check if the fuse is broken.
E-3| Ignition plug failure| 1.Check for loose ignition plug connectors and/or possibly wire short-circuit with the housing.
2.Check if the ignition plug is damaged.
E-4| Fuel pump failure| Inspect the fuel pump connection harness and connectors for damage, looseness, oxidation, short-circuits, or open circuits.
E-5| High-temperature alarm (Inlet > 50 C;
Housing > 230 C)| 1.Check if the heating airflow path is clear.
2.Verify if the fan is operating correctly.
3.Inspect if the temperature sensor is functioning properly.
E-6| Fan failure| 1.Check if the impeller is jammed.
2.nspect for any loose connection plugs.
3.Ensure proper gap between the magnet on the fan wheel and the Hall sensor on the controller.
4.Check for short-circuit or open circuit on the harness; check for motor leak electricity.
0.00E+00| Stall| 1.Check if any of the following circumstance is being found: low fuel, low-temperature solidification of fuel, fuel pipe blockage, or fuel pump jamming.
2.Inspect if the intake and exhaust airflow paths are clear.
3.Ensure sufficient contact between the housing temperature sensor and the
housing.

Photo documentation

ITL UL 588 6FT Pre Lit Christmas Tree - Figure 6ITL UL 588 6FT Pre Lit Christmas Tree - Figure
9ITL UL 588 6FT Pre Lit Christmas Tree - Figure
10

ITL UL 588 6FT Pre Lit Christmas Tree - Figure 11

ITL UL 588 6FT Pre Lit Christmas Tree - Figure 13ITL UL 588 6FT Pre Lit Christmas Tree - Figure
14ITL UL 588 6FT Pre Lit Christmas Tree - Figure
18ITL UL 588 6FT Pre Lit Christmas Tree - Figure
20

ITL UL 588 6FT Pre Lit Christmas Tree - Figure 21

*END OF REPORT
Dongguan Hongnuo Product Testing Service Co., Ltd
Address: No. 8, Jingianling Wujie, Huangjiang, Dongguan, Guangdong, China
TEL: 0769- 39001678 Website: www.i-testlab.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals