KUST 2018-2024 Car Seat Covers Luxury Leather Seat Covers Full Set Instruction Manual

Table of Contents

KUST 2018-2024 Car Seat Covers Luxury Leather Seat Covers Full Set Instruction Manual

Name	Octagonal Ring	Backpack Buckle
Logo
Quantity	2	2

passenger)

Press and hold the protrusions of two adjusting elements below and remove the headrest.
Two types of headrests: A. Directly cover the headrest, B. Then secure it with velcro.
Unzipped the side zipper of the backrest and cover the original car backrest, then adjust it to fit.
First insert the adjusting element into one side of the backrest hole, and then adjust it until fully inserted.
Zip up the zipper after adjust the fit.
Insert the octagonal ring from front to back, then turn it to the back and flip it up.
Tighten and stick the velcro firmly onto the suede at the back of the backrest.
Insert the woven tape on the seat cushion into the gap and turn it to the back to tighten it.
Pull the woven strap from the bottom to the backpack buckle.
Tie the woven strap with the backpack buckle according to the above steps and adjust it to fit.
Insert the side edge of the seat cover into the plastic part of the original car.
Take the installed headrest back to the original car seat.
Installation completed (common installation method for both driver and passenger)

Press and hold the protrusions of two adjusting elements below and remove the headrest.
Cover the headrest and set it aside.
Put down the backrest and cover it.
Take the original car strap through the reserved hole and pull it out for adjustment.
First insert the adjusting element into one side of the backrest hole, and then adjust it until fully inserted.
Insert velcro from front to back and firmly stick all velcro to the back suede.
Insert the woven tape into the gap and pull it out from the rear of the seat.
Lift the seat and pull out the woven tape.
Tie the woven strap with the backpack buckle according to the above steps and adjust it to fit.
Tie them one by one and stick the velcro on both sides tightly.
Take the installed headrest back to the original car seat.
Installation completed
Insert the octagonal ring from front to back, then turn it to the back and flip it up.
Find the foam pipes on both sides of the seat cover and insert one side first.
Insert all foam pipes into the gap between the plastic part and the seat, then flat the seat.
Take the installed headrest back to the original car seat.
Installation completed

Read User Manual Online (PDF format)