havit HV3279T-BLK-12V Shim Step Light Instruction Manual
- June 4, 2024
- havit
Table of Contents
havit HV3279T-BLK-12V Shim Step Light Instruction Manual
Product Specifications
Model No. | HV3279T-BLK-12V | HV3279T-WHT-12V |
---|---|---|
Name | Shim | |
Material | Aluminium | |
Colour | Black | White |
IP Rating | IP54 | |
Input Voltage | 12v DC | |
Lamp Base | Built in LED | |
Lamp Wattage | 1x 14w | |
Colour Temp | TRI Colour – 3000k, 4000k, 5500k | |
Lumens | 1120lm, 1155lm, 1190lm | |
CRI | > 80 | |
Wiring | Parallel | |
Dimmable | No | |
Warranty | 2 Years Replacement* |
Dimensions
Mounting Base Diagram
Important Safety Issues:
- This product must be installed by a qualified electrician according to AS/NZS 3000.
- Ensure all electrical mains are disconnected before any installation.
- Do not exceed maximum wattage restrictions for globes: 240V GU10 = 35w / 12V MR16 = 20w
- Modification of this product will void any warranty.
- Havit Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system.
- When installing low voltage fittings, Voltage to fitting must be within +or- 5% of voltage required and cannot be installed more than 25m from LED Driver, if not within this allowance warranty will be voided.
- Aluminium and 304SS fittings must not be installed within 2km of any salt water environments.
- When installing copper fittings, gloves must be worn to avoid any oils transferring to fitting.
- All 316 stainless steel fittings must have regular cleaning maintenance to avoid any tea staining from forming on fitting. (Warranty does not cover Tea Staining)
- All o-rings and seals must be in place correctly to maintain warranty.
- These instructions may be updated at any time due to product improvements, Please visit website for most current installation instructions.
Steps for Installation:
- Make sure that the electrical circuit is free of voltage (master switch off )
- Loosen allen screws on side of fitting and remove face and set aside.
- Install base plate to wall in desired location
- Using an appropriate 12v DC LED Driver – DO NOT CONNECT LIGHT FITTING DIRECTLY TO 240V
- Connect the cable – If more than one fitting installed, wiring must be done in parallel.
- Fitting is preset to 3000k, to change slide switch to desired colour temperature
- Reattach face to base plate making sure allen screws are tight to avoid water penetration
- Apply silicon around edge of fitting to prevent any water from getting inside to electrical connections.
- All connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.
Must be installed by a licensed electrician
Contact Details:
143 Beauchamp Road Matraville NSW 2036 Australia
Tel: 02 9381 8300
Fax: 02 9666 8881
Email: sales@havit.com.au
Web: www.havit.com.au
Warranty Terms & Conditions*
HV3278T-BLK-12V
HV3278T-WHT-12V
Documents / Resources
|
havit HV3279T-BLK-12V Shim Step
Light
[pdf] Instruction Manual
HV3279T-BLK-12V, Shim Step Light, Step Light, Shim Light, Light, HV3279T-BLK-
12V
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>