Jadisi LOYOELE 2 Pack 3200W Solar Street Light User Manual

June 16, 2024
Jadisi

LOYOELE 2 Pack 3200W Solar Street Light

Solar Street Light
User Manual

Thanks so much for choosing our solar street lig ht. For any further questions, please emailus.

Warm Tips

Step 1: Turn on the switch (Long Press Button)
Step 2: Charging 2 hours under the sunlight
Step 3: Test the remote controller work or not
(Note: Remote control is pointed at the receiver)
Follow the instruction when you received

  1. Block the light sensor part (solar panel) and Turn on the switeh (Long Press Button).
    Jadisi LOYOELE 2 Pack 3200W Solar Street Light - assembly
1

  2. Charging 2 hours under the sunlight, The indicator light flashes to indicate that itis charging, the color of the fully charged indicator light is 2 red lights + 2 blue lights + 1 green light Undicater no longer flashes)
    Jadisi LOYOELE 2 Pack 3200W Solar Street Light - assembly
2

  3. Test the remotecontroller work or not. (Note: Remote control is pointed at the receiver) Jadisi LOYOELE 2 Pack 3200W Solar Street Light - assembly 3

Package

  1. Sloar light
  2. Fixing arm pole
  3. Backplate for pole mounting
  4. Backplate for luminaire mounting
  5. Remote control
  6. Open spanner
  7. Batttary
  8. Wall mount bolts
  9. Long bolts for pole mounting
  10. Short bolts for luminaire mounting

Jadisi LOYOELE 2 Pack 3200W Solar Street Light - assembly
4

Installation

Jadisi LOYOELE 2 Pack 3200W Solar Street Light - assembly
5

Wall Mount

Jadisi LOYOELE 2 Pack 3200W Solar Street Light - assembly
6 On the wail
Step 1: Mark the hole loction, Drill 4 holes in the wall according to the position of the bracket’s hole.
Step 2: Knock the bolts into the wall.
Step 3: Mount the light, lock the screws and tighten them.

Pole Mount

Jadisi LOYOELE 2 Pack 3200W Solar Street Light - assembly
7On the pole
Step1 :Secure the light to the pole with the long bolt and back plate.
Step2: then tighten the long bolt .

Ledindicator meaning

Jadisi LOYOELE 2 Pack 3200W Solar Street Light - assembly
8 Note: Please long press ” ” until the light turns on.

Power display meaning

Jadisi LOYOELE 2 Pack 3200W Solar Street Light - assembly
9When fully charged, all indicator lights will be on (2 red lights+ 2 bule lights+ 1 greenlight),the color of the battery indicator will not change.

Motion Sensor Mode

  • Please insert the 2 batteries (1.5 V AAA type). Make sure that the positive and negative ends are facing in the correct direction. the control distance of remote is 35ft.Jadisi LOYOELE 2 Pack 3200W Solar Street Light - assembly 10

    1. When you press the button ON, the solar street light will be 100% brightness.

    2. When you press the button OFF, the solar street light will be turned off and cannot be turned on automatically until the next day. (Tips: You need to press on the light body to turn off the solar street light completely.)

    3. Motion Sensor Mode:When motion is detected, the brightness increases to 100%.
      When there is no motion, it is stationary for about 10-20 seconds and the brightness returns to 30%.

    4. Timed Lighting: Timed 100% brightness Lighting 2/3/5/6/8 hours without radar sense motion function.

    5. Brightness level: you can set up the brightness level {25% / 50%/ 75%/100%) of the light.

Remote Control Buttons

Jadisi LOYOELE 2 Pack 3200W Solar Street Light - assembly
11

How does your solar powered fixture work?

  1. During the day, the solar converts sunlight into electricity and recharge thebattery. At night, the light turn on automatically using the electricity storedduring that day.
  2. The number of hours the lights depends on your geographicallocations, weather conditions and seasonal sunlight availability.Also.itdepends on the lighting time you choose.
  3. Place the solar light fixture in an area where it can receive direct sunlight forat least 8 hours each day. Shadowed locations should not be near lights.asthese may cause the solar light to turn off prematurely.

Precautions

  1. First time ofuse,place the solar light in a location where it can receive a full8 hour of sunlight to allow the rechargeable battery to reach maximum capacity.

  2. Then put the solar panel in the sun to charge
    Please choose a position without any shelter forenough sunshine and the solar panel should be fully exposured under sun.

  3. Keep the solar panel surface clean, this helps speed up charging. It is suggested to clean the solar panel for a period of time.

  4. The light will turn off after run out of battery especially in area that lack of sunlight, in cloudy winter and during long rainy weeks. If such problem occur.first press OFF charge the solar panel for two days and then turn on .

  5. Test light control: After blocked the solar panel. press the “  ” button, the lightison;  the solar panel is facing the sun light, the light is off. then the light controlisnormal.

Troubleshooting

If the light does not turn on at dusk after 8 hours of charging:Ensure that the solar light fixture is in a bright sunny location and not ina shady area during the day.
Make sure that the solar light fixture is turned on(Auto)
*Make sure that the remote control battery has power.
“If the above faults are eliminated, it may be that the solar battery needsto be replaced or the controller is faulty. Please contact me in time.

Warranty

We provide our customers with a warranty of 12 months from the date of purchase.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals