PEGASI H1 Soccer Full Size Hand Football Table Instruction Manual

PEGASI H1 Soccer Full Size Hand Football Table

PARTS IDENTIFIER

HARDWARE

ACCESSORIES

ASSEMBLY PARTS

REPLACEMENT PARTS

ASSEMBLY INSTRUCTIONS

SOCCER TABLE ASSEMBLY

1. ATTACH THE END PANEL BRACKET P17 TO THE INSIDE OF P2B AND P2C.
   PLACE SIDE PANELS P1 UPSIDE DOWN WITH THE SLOT FACING INWARD AS SHOWN IN figure 1 . (BALL ENTRY HOLE WILL BE CLOSEST TO THE FLOOR.)

2. ATTACH THE TWO END PANELS P2B TO THE SIDEPANEL P1 WITH SCREW H3 AS SHOWN IN figure 1.

3. ATTACH THE TWO END PANELS P2A TO THE SIDEPANEL P1 WITH SCREW H4 AS SHOWN IN figure 1

4. SET THE PLAYFIELD P3 ONTO THE ASSEMBLY AND ATTACH WITH SCREWS H3 AS SHOWN IN FIGURE 2.
   PLACE THE PLAYFIELD SUPORT BRACES ON THE BOTTOM OF THE PLAYFIELD. ATTATCH THE BRACES USING BRACKETS P17 AND SCREWS H4. AS SHOWN IN FIGURE 2.
   ATTACH THE BRACKET P6 TO THE SIDE PANELS AND THE PLAYFIELD WITH SCREWS H4 AS SHOWN IN figure 2.
   WARNING: TWO ADULTS NEEDED TO ASSEMBLE SOCCER TABLE

5. INSERT THE CORNER P16 TO THE SIDE PANELS AND THE END PANEL P2C . FIXED IT WITH SCREWS H4 AS SHOWN IN figure 3. ASSEMBLY THE END PANEL P2C WITH SCREW H4 AS SHOWN IN figure 3

6. INSERT CROSS BAR P15 INTO LEGS AS SHOWN IN FIGURE 4.
   ATTACH THE LEGS P4A&P4B AS SHOWN IN figure 4.
   THE LEGS ARE ATTACHED WITH BOLTS H1 AND WASHERS H2.
   *TIGHTEN HARDWARE AT THIS TIME!

7. PLACE THE GOAL P12 OVER THE HOLE IN THE END PANEL AND ATTACH USING SCREWS H4. PLACE THE BALL CATCHER P11 OVER THE HOLE IN THE SIDE PANEL AND ATTACH USING SCREWS H4. SECURE THE BALL RUNNER P13 BETWEEN EACH GOAL AND BALL CATCHER. SEE figure 4.
   (REPEAT ABOVE STEP FOR OTHER END OF TABLE)

8. ATTACH THE LEG LEVELERS P10 AS SHOWN IN figure 4.
   WARNING
   This step requires two adults!
   Very carefully turn the table over and set on its legs. Be careful!

9. ATTACH BALL ENTRY CUPS P9A AND BALL ENTRY SOCKET P9B
   TO THE SIDE PANELS WITH SCREWS H5 AS SHOWN IN figure 5.
   ATTACH THE TWO SETS OF SLIDE SCORER P14 TO THE END OF TABLE WITH SCREWS H6.

10. PLACE THE TRIANGLES P18 ON THE CORNER OF PLAYING SURFACE USING SCREWS H7, THEN INSERT THE PLUGS P19 TO COVER THE HOLE.

11. INSERT THE PLAYER RODS C1&C2&C3 THROUGH ONE SIDE PANEL,THEN INSERT PLAYERS C8&C9, RBBBER BUSHINGS C4, PLASTIC WASHERS C5 THROUGH THE ROD, THEN INSERT THE PLAYER ROD THROUGH OTHER SIDE PANEL, ATTACH THE PLAYERS C8&C9 WITH BOLTS C6 AND NUTS C7. SEE Figure 6.

12. SLIDE THE HANDLES P7 ONTO THE ENDS OF THE RODS.
    SLIDE THE RUBBER CAPS P8 ON THE OTHER END OF THE ROD .

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>