SILVERMINE Stone Pillar Kits Instructions
- June 4, 2024
- SILVERMINE
Table of Contents
SILVERMINE Stone Pillar Kits
Pillar Kits Instructions
The First Brand of Mortarless Stone Veneer
Pillar Kit Includes
Pillar Frame Kit
- Right Side Panel
- Left Side Panel
- Back Side Panel
- Upper Front Panel
- Lower Front Panel
- Stainless Steel Frame Assembly Screws Top Frame Plate
- Silvermine Stone Fasteners
- Pillar Cap
- Pre-Cut Pillar Stones
36â Pillar Kit …………………….3 boxes
48â Pillar Kit …………………….4 boxes
Tools Needed (not included)
ASSEMBLE THE FRAME
NEEDED ITEMS FOR THIS STEP
STEP-BY-STEP
- ATTACH – Back Panel to Right Side Panel using (5) stainless steel screws
- ATTACH – Left Side Panel to Back Panel using (5) stainless steel screws
- ATTACH – Long Front Side Panel to the TOP of Left Side Panel using (3) stainless steel screws
- ATTACH – Long Front Side Panel to the TOP of Right Side Panel using (3) stainless steel screw
- Insert top plate onto assembled frame sides
MOUNTING THE FRAME
NEEDED ITEMS FOR THIS STEP
STEP-BY-STEP
- Set assembled pillar frame in place with the 2×4 base blocks on the bottom
- Use Level (not included) to ensure frame is plumb – Shim if necessary
- Attach mounting blocks to your base with appropriate mounting hardware (not included) (See local building codes)
- Attached short, front panel to pillar frame using stainless steel screws to fully enclose it
ATTACHING THE FIRST COURSE OF STONE
NEEDED ITEMS FOR THIS STEP
- Use a temporary support (1/2” wood piece or similar material – not included) to support first course of pillar stone and keep it level with the bottom edge of the pillar frame.
- Attach Pillar Stone to Pillar Frame with Silvermine Stone Fastener
- Use 2 screws per panel
- Place screw 3/4” – 1” above pillar stone and 1” from the edge, into the metal flashing.
- Use Level
- Repeat Step 3B for the remaining bottom course of pillar stones
TIP: Be sure to use your level! The first row sets the stage for the remaining stone layers – so be diligent on making sure this row is level .
BUILDING UP YOUR STONE PILLAR
NEEDED ITEMS FOR THIS STEP
-
Remove temporary support
-
Repeat Step 3B for each course of stone*
- Make sure that each stone is firmly in contact with the stone below it When ONE COURSE of stone remains to have adhered…
-
Bend metal flashing horizontally
-
Install the last course of pillar stone by attaching the (now horizontal) flashing to the top of the pillar frame
NOTE: Each piece of flashing should have 2 screws – but as panels overlap, it is okay to use one screw to hold multiple pieces -
Using a bead of construction adhesive (not included), install the pillar cap to the top of your built pillar structure