IDEAL L2 Gen II Lever Wire Connectors Installation Guide
- June 16, 2024
- IDEAL
Table of Contents
Installation Instructions – Gen II Lever Wire Connectors
Models L2, L3 & L5
-
Do not exceed the rating of these connectors
-
Turn OFF power before removing or installing connectors
-
Wiring must comply with all applicable electrical regulations
-
COPPER TO COPPER ONLY. Do not use on aluminium wire.
-
Incorrect use of these connectors can cause electrical fires, personal injury or death
-
Use only one conductor per port · Strip wires back 11-12mm
-
For solid and rigid stranded wire, grip wire firmly and insert conductor into open port
(lever does not need to be open) -
For flexible stranded wire (>7 strands) lift lever and insert conductor into open port. Close lever
-
Verify conductors are fully inserted to the back of the connector. · To remove a wire, lift lever and pull out wire
Strip Length
Insertion
Removal
Specifications|
Model L2 2-Port
| Model L3 3-Port|
Model L5 5-Port
---|---|---|---
Rating|
32 Amp / 450V / 85°
Depth|
18.6 mm
Width|
13.3 mm
| 18.9 mm|
30.4 mm
Height|
8.8 mm
Wire Combination Range| Solid and Rigid Stranded|
0.2mm² – 4.0mm²
Flexible Wires|
0.14mm² – 4.0mm²
Documents / Resources
|
IDEAL L2 Gen II Lever Wire
Connectors
[pdf] Installation Guide
L2, L3, L5, L2 Gen II Lever Wire Connectors, Gen II Lever Wire Connectors,
Lever Wire Connectors, Wire Connectors, Connectors
---|---