Lorima 13-13 Pro Cup Holder Phone Mount User Manual

Lorima 13-13 Pro Cup Holder Phone Mount

Packing List

• Cup Holder Base

• Cup Holder Mount

• Silicone extend case * 3

• Screw

• Mount Nut

Installation Steps:

1. Place the mount nut on cup holder.

2. Place the screw on the cup holder again.

3. Tighten the mount nut.

4. Line up the phone mount and holder (the direction same as photo).
   

5. Hold neck and press phone mount down with your thumb to tight the phone holder
   ( NOTE: when your hear the “ti-tak”, means you are installing correctly.)

6. Done!

Press this button behind the phone holder to expand the clip.

1. Place the base in your vehicle cup holder.
   

2. Twist the serrated cone-shaped part ofthe base to fit the holder (clockwise tightly, anticlockwise loose).
   

Silicone extend case

If you have large cup holder(diameter size is larger than 3.5in, less than 4in).
We provide the silicone extend cases for your cup holder to fit better.

Put each silicone case (as shown below) to the base.
These cases can be extended to 4in.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>