GANGMEI XA6-25 Safe Deposit Box Instruction Manual

GANGMEI XA6-25 Safe Deposit Box Instruction Manual

Thank you for choosing our products!
Please take time to read and familiarize yourself with the proper operating procedures presented on the following pages.

XA6-25/35/45 SERIES SAFE DEPOSIT BOX INSTRUCTION GUIDE

Accessories

Warning

1. Do not lock the emergency key or external battery box into the cabinet.
2. If the safe box will not used for a long time, please remove its battery.
3. Purchase 4 AA batteries in advance, this safe does not contain batteries.

How to Use Your Safe Box ?

Operating Instructions

1. The light flashes once every time an operation key is pressed.
2. The “#” key on the operation keypad is used to indicate start and confirmation.
3. After any key is pressed, if there is no subsequent key input for 7 seconds, the lock will enter the sleep state.
4. Once it enters the sleep state, all operations will stop. Wake up the screen with your palm to enter the function operation.
5. During input, you can press ” ” key to delete all the * input and re-enter.

How to Set or Change the Password ?

Vibration Alarm

(1) To set the alarm, touch the key area with the back or palm of the hand, press ” “, beep once and the computer board will automatically enter alarm mode. If the safe box is vibrated, the built-in alarm will sound immediately.
(2) To relieve the alarm, touch the key area with the back or palm of the hand, enter the password, and then press “#” to open the door and relieve the alarm. When the alarm is relieved, you need set the alarm again to start it.

Undervoltage Indication

1. When the battery voltage is low, when the unlocking light lights up, there will be four beep-beep-beep-beep-. The lock can still work for a period of time, but it is recommended to replace the battery as soon as possible.
2. This model contains a memory chip, so the password protection will not be lost after a power failure

Technical Parameters

1. Working power supply: four 5th AA alkaline batteries
2. Working voltage range: 4.0V～6.8V
3. Working undervoltage point: 4.60V±0.30V
4. Working current: ≤380mA
5. Static current: <30uA
6. Working temperature: -10℃-+70℃
7. Working humidity: 10%-90%RH

How to Use Emergency Battery Box ?

When the safe box’s battery is too low to open the door, insert 4 AA 1.5 batteries in the emergency battery box, plug the emergency power cord into the emergency power jack on the bottom edge of the panel, then enter the correct password to open the door.

How to Install Foot Mat ?

Remove the sticker of the foot mat and install it on the bottom.

How to Mount the Safe ?

1. Place the safe on the installation location, find the installation holes from the inside of the safe, mark the drilling points from the inner installation holes, then remove the safe and drill two holes.
2. Take the expansion bolt out of the casing and put it into the drilled hole, then align
   the pre-drilled hole with the inner hole of the safe, and then insert the expansion bolt
   into the casing from the inside of the safe.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>