Manfrotto 5002BL Nano Plus Stand With Levelling Leg Instructions
- June 16, 2024
- Manfrotto
Table of Contents
INSTRUCTIONS
5002BL
INTRODUCTION
The Manfrotto “Nano Plus Stand With Levelling Leg” is a versatile stand for use on location and in studio. Thanks to its features, it brings new possibilities to the photographer, while making their job easier. Designed to support a payload of up to 4 Kg, this stand is lightweight and compact, to guarantee maximum portability. Perfect for use with lightweight lighting products such as battery powered monolights and LED panels and when used in combination with the Manfrotto “Snap Tilthead”, it represents a perfect solution for supporting flashguns in different applications.
PRODUCT BENEFITS
- Lightweight and compact, but at the same time very stable
- Quick to set-up
TECHNICAL FEATURES
- Column extension collars are pressure die cast aluminium
- Maximum payload: 4 kg
- Top attachment: 16 mm (5/8”) male top stud with 3/8” or 1/4” thread
- Maximum height: 197 cm
- Maximum height when closed: 52 cm
SET UP
Lighting stands must always be set-up on firm ground, capable of supporting the weight of both the stand and the load. The ground should be flat; in case it’s not, use the levelling leg to realign the column on vertical axis (fig. 7).
HOW TO OPEN THE BASE 1
Unlock knob “A”, press upper casting “B” down and spread the legs “C”
outwards. To obtain maximum stability, position the upper casting right on the
indication “Max stability”, which you can find written on the column. Lock the
legs and base by tightening the knob “A”. The centre column must never touch
the ground as this adversely effects the stability of the stand.
OPERATING INSTRUCTIONS 2 & 3
Never exceed the maximum payload (see the section “Technical Features”).
LOADING: See fig. 2 and 3 for loading instructions.
When using a T bar, loads should be balanced (fig. 3).
HEIGHT ADJUSTMENT 4, 5 & 6
The stand has a telescopic centre column for height adjustment.
Locking knobs (fig. 4) are used to secure the risers in place.
Make sure that each riser of the column is locked tightly by applying pressure
down, before loading the stand. This should be checked regularly (fig. 5) For
your own safety, when lowering each telescopic section of the column, firmly
support the load (fig. 6) by holding the relevant section with one hand,
whilst unlocking the knob. It is recommended not to move stands with raised
columns and applied load.
Before starting to use the Manfrotto Nano Plus Stand Stand, please ensure you
carefully read through the document “General Instructions and Warnings”, which
you find attached.
Cod. 1101464 – 05/19
Copyright © 2019 Manfrotto Bassano Italy
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>