PSI Woodworking LR110-3 Long Ranger III 110V Remote Dust Collector Starter Switch User Manual
- June 16, 2024
- PSI Woodworking
Table of Contents
PSI Woodworking LR110-3 Long Ranger III 110V Remote Dust Collector Starter Switch
Basics of Programming
The new Long Ranger Ill™ now ships with a unique code that should not conflict with any other Long Ranger unit. All Long Ranger Ill™ units are now user programmable. The transmitter and receiver are matched to work together when shipped as a system using a factory set code. The codes are set in the transmitter and are picked up by the receiver when properly programmed.
If programming is necessary:
Plug in receiver to outlet. Plug in dust collector to receiver and make sure
dust collector is turned on.
Step A – To erase the frequency code in memory in a receiver:
Press and hold the button on the receiver; you will her a single beep, then a
triple beep within 7 seconds, then release.
This will erase the current code in memory in the receiver.
Step B – To match the receiver to the transmitter code:
Check battery in transmitter, if red indicator light is dim or flickers,
replace the 9volt battery.
Press the button on the receiver, and release. (You will hear a single beep)
Within 5 seconds press either the On or Off button on the transmitter once.
(You will hear a double beep) Immediately press either the On or Off button
again on the transmitter. (You will hear a triple beep)
This will result in the receiver now programmed to operate via the transmitter.
Note: If the user desires to have any transmitters operate a single receiver, follow step B listed above. Numerous transmitters can now be in the memory of a single receiver. In the event that the user needs to operate more than one receiver from a single transmitter, follow step B listed above. Numerous receivers can now all respond to a single transmitter.
To delete the memory between a receiver and a transmitter, follow step A listed above.
Customer Support
© 2019 PSI Woodworking Philadelphia PA 19115 – v6/19