PRINCEWAY RS-W32 Wall Light Remote Control Owner’s Manual
- June 16, 2024
- PRINCEWAY
Table of Contents
**PRINCEWAY RS-W32 Wall Light Remote Control Owner’s Manual
**
Packing List
1X Lamp 1X Power Adapter 1X Support Plate
1X Tape 3X Expansion Screws
3X Steel Screws 1X Remote Control
Code matching before first usage:
- Remove the insulation sheet from remote control, then keep pressing OFF button and not release
- Plug power adapter into power socket, wait for 5~10 seconds, the lamp will flash once. The code matching is successful
Remind:
If the code matching is failed, please don’t worry, press the touch switch to
turn on lamp and remove the power adapter from power socket. It can initialize
the lamp, then begin new code matching process
Wall Light Remote Control
| SKU | RS-W32 | Control Mode | Remote Control |
|---|---|---|---|
| Material | Plastic ABS | Dimension | 50.4 X 6 X 3 CM |
| Lighting Source | COB LED | Input Voltage | AC100-240V 50/60HZ |
| USB Output | DC5V Max.2A | Power | Max.5W |
| Lighting Brightness | Max.500Lm | Lighting Color | 4000K |
| CRI | CRI>80 | Waterproof Rate | IP20 |
FCC warning :
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Installation Methods
Fix the support plate on the wooden surface with steel screws, and then slide the lamp base onto the support plate.
Fix the expansion screws on the wall, then fix the support plate on the wall with the steel screws, and then slide the lamp base onto the support plate
Use tape to stick the support plate on the required surface, and then slide the lamp base onto the support plate.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC warning:
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authoritytooperate the equipmen
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15of theca Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance withtheinstructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which canbedetermined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
service@princewaylighting.com
www.princewaylighting.com Made in
China
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>