ArimAir RA300 Air Quality Monitor User Manual
- June 16, 2024
- ARIM
Table of Contents
User manual ArimAir RW300
Overview
The ArimAir RA300 is a real-time air quality meter that simultaneously
measures particulate matter (PM 2.5), radon, carbon dioxide (CO2), volatile
organic compounds (VOCs), temperature, and humidity.
It is equipped with a display that shows air quality information in real time,
and has been certified as Grade 1 for fine particulate matter performance.
Components
- ArimAir RA300
- USB-C Cable
Specification
| Manufacturer | ARIM SCIENCE Inc. |
|---|---|
| Model | ArimAir RA300 |
| Measurement | PM2.5, RADON, CO2,, VOC, TEMP, HUMI |
| Measurement range | PM 2.5 |
| PM 10 | Measurement Range |
| Measurement Sensitivity | 1 µg/m3 |
| Accuracy | ±10 µg/m3 (0 ~ 100 µg/m3) |
±10 % (00 ~ 1,000 µg/m3)
Particle Size Sensitivity| 0.3 ~ 10 µm
Flow Rate| 1.3 CFM
Response Time| ≤ 1 sec
Linearity| R2 = 0.9897
RADON| Range| 0.2 ~ 99.9pCi/L
(7~3,700Bq/㎥)
Sensitivity| 0.3cpm/pCi/L
Accuracy| < ±15%
CO2| Range| 0 – 40,000 ppm
Accuracy| ± (50 ppm + 5% of reading)
Response time| 60 s
VOC| Range| 0 – 1000 ppm
Output signals| 1 – 500 VOC Index
Response time| 10 s
TEMPERATURE| Accuracy@Range| ±0.2@-40 ~ 125 °C
Resolution| 0.01 °C
Response time| 2 s
HUMIDITY| Accuracy@Range| ±1.8@0-100% RH
Communication| WIFI, USB Serial
Power| 5V 2A
Certificates
KC Certification (ArimAir RA300)
Registration of Broadcasting and Communication Equipments
Trade Name or Registrant|
Eauipment Name| ArimAir RA300
Equipment code /Additional Equipment code| IMI61 I LARNE
Basic Model Number| ArimAir RA300W
Series Model Number|
RA300-W03458
Registration No.| R-R-iAR-RA300W
Manufacturer/Country of Origin|
Date of Registration| 2022-11-25
Others|
It is verified that foregoing equipment has been registered under the Clause
3, Article 58-2 of Radio Waves Act.
Director General of National Radio Research Agency
ESP32-WROOM-32E (Certificates Attachment)
ESP32-WROOM-32E NCC Certification
ESP32-WROOM-32E & ESP32-WROOM-32UE KCC Certification
ESP32-WROVER-E & ESP32-WROVER-IE & ESP32-WROOM-32E & ESP32-WROOM-32UE BQB
Certification
ESP32-WROOM-32E MIC Certification
ESP32-WROOM-32E IC Certification
ESP32-WROOM-32E Wi-Fi Certification
ESP32-WROOM-32E SRRC Certification
ESP32-WROOM-32E FCC DTS Certification
ESP32-WROOM-32E CE Certification
ESP32-WROOM-32E CE Certification Appendix
ESP32-WROOM-32E FCC DSS Certification
Install
Set up the ArimAir RA300. Connecting to power
Connect the USB-C cable to the RA300W rear connector. Power off
Unplug the USB-C cable to disconnect power
Operation
- Red box: Metrics
- Green box : Value
- Bottom left: Current status visualization
- Bottom right : Temperature and humidity
FCC Compliance Statement(FCC ID: 2BDYS-RA300)
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference. and
- This device must accept any interference received, including interference that may cause undesired operation.
Caution
Any changes or modifications (including the antenna) made to this device that
are not expressly approved by the manufacturer may void the user’s authority
to operate the equipment.
To comply with FCC RF exposure compliance requirements, a separation distance
of at least 20 cm must be maintained between the antenna of this device and
all persons. This device must not be co-located or operation in conjunction
with any other antenna or transmitter.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC
ARIM SCIENCE Inc.
Daedeok-gu, Daejeon, Republic of Korea
66, Daehwa-ro 106beon-gil
918ho, Pentaplex
Web : www.arimsc.com
E-mail : pjr@arimsc.com
Tel : (+82)10-5036-5635
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>