NV-CAM01-SOLAR4G Solar PT Camera User Guide

NV-CAM01-SOLAR4G Solar PT Camera User Guide

Please read the Quick Guide carefully before using the product and keep it properly.

Packing list

Note: Product sales configuration is different

Please refer to the actual product

NV-CAM01-SOLAR4G

NV-CAM02S-SOLAR4G

Interface description

Note:
1. Connect the camera to the solar panel, and confirm that the solar panel switch is on.
2. turn on the camera switch.
3. dial the solar panel switch to “ON” to turn on, and “OFF” turn off.

(*Note: Please open the speaker cover when using the reset button / SD cardslot.)

The instructions of LED light

• Geen light flashes for 2s and goes out: The device is powered on and connecting to the network
• Green light + red light is always on: The camera is being previewed remotely (privacy light)
• Green light is always on: The device is connected to the network or awakened
• Green light flashes continuously: Upgrading
• Green light flashes continuously and slowly: Charging
• Red light flashes 3 times quickly: Power off
• Red light is always on: Low battery
• The traffic light is always off: In standby

Button operations

• Press the reset button and hold for 3s: Turn on
• Press the reset button 3 times continuously: Power off
• Press the reset button and hold for 5s in the power-on state: Reset

APP Installation and Login

Download and Install “Eseecloud”

Users can search “EseeCloud(IP Pro, VR Cam)” on APP store or Google Play,or scan the QR code below to install the APP.

Note: For iOS system, it requires iOS 9.0 version or above.
For Android,Android 5.1 or above.

Account login
Account login: On the login interface, input the account /phone number/email, and the corresponding password, and click the “OK” button to log in.

Third-party login: APP supports third-party login. Click the third-party social software icon, jump to the APP to complete the authorization and log in.

Adding the camera

4G mode added

1. When the device is powered off, insert a 4G card that can access the Internet into the device;

Note: please use the 4G card that comes with the product or other cards that has not been activated.
If replaced with another 4G card that has been activated, it will cause the card to be locked.

When the QR code of the device cannot be found (or the scan code is unsuccessful)：

Description of the flow recharge process and unlock process of 4G camera

If your 4G device cannot be recharged online after successfully adding it, please click “Mall” in the tab bar at the bottom of the APP, and recharge the device in the 4G data flow.

4G card unlocking process

Note: The unlocking time depends on local operators, and it is expected to be normal within one hour.

Installation method

**** PIR is sensitive to hot and cold disturbances, please note:

• Avoid installing the camera where the air flow is agitated. For example: the air outlet of the air conditioner, the heat dissipation port of the equipment, the side of the fan, the vicinity of the curtain, etc.

• Please do not install the camera in front of the glass or mirror.
  The height of the camera installation should be 2.5M-3M, the best distance of PIR trigger.

• Do not install the camera upside down.

1. Ceiling installation/wall installation

2. The pole installation

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>