EXXENTRIC kBox4 Active Starter System Installation Guide
- June 15, 2024
- EXXENTRIC
Table of Contents
**EXXENTRIC kBox4 Active Starter System Installation Guide
**
Installation Guide
Step 1
Flip the kBox over and remove the Snap-on Shaft Cover by hand.
Step 2
Snap off the Battery Cover with a flat screwdriver
Step 3
Slide in your new kMeter II so that the screws of the Chassis fit into the
openings on the kMeter II’s plastic base.
Note! Make sure the Sensor Disk is centered and as deep down as possible
into the Reading Fork without touching the Reading Fork or the Circuit Board.
Step 4
Secure the kMeter II in place by carefully tightening the M6 nuts with a
10mm wrench
Step 5
Snap the Battery Cover back on after installing the kMeter II
If you need further assistance, please contact us through https://exxentric.com/support/
Documents / Resources
|
EXXENTRIC kBox4 Active Starter
System
[pdf] Installation Guide
kBox4, kBox4 Active Starter System, Active Starter System, Starter System,
System
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>