STEAJIC AB305S Wireless Charging Photographic Handle User Manual

: June 15, 2024
: STEAJIC

Table of Contents

STEAJIC AB305S Wireless Charging Photographic Handle User Manual
Product Introduction
Specifications
- References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

STEAJIC AB305S Wireless Charging Photographic Handle User Manual

Oth-AB305S

www.osmdigi.com

Product Introduction

FIG 1 Product Introduction.JPG

Bluetooth pairing:
Press and hold it for 2 seconds to power on。When the green indicator flickers, enable Bluetooth on your mobile phone to search for “SEA JIC”, then click on it to connect; the green indicator will be always on after successful connection。
To take photos/videos, just short press “Bluetooth/Camera” (some phones may not support taking videos)。
It will enter sleep mode in case of no connection or no key operation in 10 minutes after connection, and will be shut down automatically in 30 minutes in sleep mode。

Note: when the Bluetooth doesn’t work, please enable it again by poking with your SIM card pin or another hard object。Static storage duration in shutdown mode: charging it every 6 months is recommended。

Specifications

Parameters of the Magnetic Wireless Charger:
Boundary dimension: 120x87x50mm
Weight: 216g
Bluetooth transmission distance: 10m
Input/output voltage: 5V/2A
Input/output interface: Type-C
Wireless charging efficiency: 75% (max)
Wireless charging power: 5W
Battery capacity/voltage: 4,000mAh/3.7V (18,650/2,000 mAh*2)
Material: ABS (fireproofing) PC (fireproofing) Aluminum alloy

FCC Caution

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction

Read More About This Manual & Download PDF: