BRAVUR 231130 Smart Watch Owner’s Manual
- June 15, 2024
- BRAVUR
Table of Contents
BRAVUR 231130 Smart Watch
THANK YOU!
Thank you for chosing a watch from Bravur!
Your watch has been designed, assembled and tested in Sweden, with the
greatest care and attention to details. We hope you will enjoy your new watch
for many years to come!
Kind regards,
Magnus & Johan, founders
SETTING THE TIME & CHRONOGRAPH FUNCTIONS
- Minute hand
- Hour hand
- Running seconds
- 60 seconds chronograph
- 15 minute counter
- 12 hour counter
- Chronograph start/stop pusher
- Chronograph reset pusher
- Crown with two positions
Setting the time
- Gently pull out the crown (9) to position B to move the hour and minute hands.
- Turn the crown clockwise or counterclockwise to set the correct time. Note that the second hand stops in this position.
- After setting the time, push the crown back to position A for normal use and water protection.
In case your watch has stopped after not being used for a period of time, it’s recommended to manually wind it to start. This is done with the crown in position A. The crown should be turned clockwise, seen from the side, approximately 15-20 turns.
Chronograph function
- Use the upper push button (7) to start and stop the chronograph.
- The center chronograph hand (4) runs when started, and minutes and hours are counted on sub-dials (5 and 6).
- Press the lower push button (8) to reset the chronograph
CARE & MAINTENANCE
Please follow these guidelines to get the best performance from your watch.
Movement
If the watch is worn for 12 or more hours daily, the automatic rotor winds the
movement, eliminating the need for manual winding. In case the watch has
stopped due to non-use, it’s advisable to manually wind it using the crown in
position A. Rotate the crown clockwise approximately 15-20 turns. Please note
that regular daily wear may not fully wind the movement, and a 62-hour power
reserve cannot be guaranteed. For individuals with a sedentary lifestyle,
manual winding may be necessary to ensure the watch stays operational.
The accuracy stated in the specifications section may change over time. As a
mechanical watch, quartz watch accuracy cannot be expected.
Magnetic fields
Avoid exposing your watch to strong magnetic fields, such as those generated
by X-ray machines and loudspeakers, as it can magnetize the watch movement,
negatively affecting its performance and accuracy.
Shocks
Avoid exposing your watch to mechanical and thermal shocks as it may damage
the delicate moving parts of the watch.
Service
Your watch consists of hundreds of small parts and needs occasional service to
maintain its performance and accuracy. Full service is advised every 4-5
years. Service should be performed by an approved watch maker or sent to a
Bravur service center. Contact us for more information.
Cleaning
You may use a damp cloth to clean your watch. A tooth brush and some water
with mild detergent may be used for a more serious cleaning. Prevent the
leather strap from coming in contact with moisture.
Water resistance
Your watch is tested to resist 10 ATM of static pressure in a controlled
environment when new. Please note that this is not equivalent to water
resistance. 10 ATM means it’s suitable for swimming but not scuba diving. The
optional leather strap is not suitable for swimming. Gaskets and seals should
be inspected and replaced regularly by a watchmaker to maintain full water
resistance. Note that the crown must be in position A to be protected from
water and the chronograph function must not be operated.
Leather strap (optional)
Avoid letting leather straps come in contact with water, as it will shorten
their lifespan.
SPECIFICATIONS
- Movement Swiss Made Sellita SW511b, 27 jewels, rhodium plated, self-winding, stop second device, decorated rotor
- Power reserve Up to 62 hours
- Frequency 28 800 (4 Hz) 8 beats per second
- Accuracy Daily rate +/- 5 s/d Isochronism (after 24h) +/- 15 s/d
- Sub dials 15-minute counter at 3H, 12-hour counter at 6H and running seconds at 9H.
- Case Stainless steel, 316L, 38.2 mm Some versions: PVD coating
- Case back Flat sapphire crystal
- Lug width 18 mm
- Crystal Domed sapphire, inside anti-reflective coating.
- Hands
- Hour and minute: Rhodium plated, Super-LumiNova
- Water resistance 10 ATM
HANDBUILT IN BÅSTAD, SWEDEN
MEASUREMENTS
WARRANTY
- Your Bravur watch is covered by a comprehensive two-year warranty from the original date of purchase.
- The warranty encompasses repairs necessary due to defects in materials or workmanship under normal use.
- Bravur’s commitments in this regard are limited to repair or replacement at its discretion.
- Please note that the warranty excludes the strap/bracelet and damage from excessive wear to the case, plating, crystal, or strap.
- It’s important to understand that the warranty does not extend to cover periodic service and maintenance.
- Any service, maintenance, repairs, or servicing that is improperly or incorrectly performed will void the warranty. If the service and maintenance, repairs, or servicing require opening the case, it must be conducted by a qualified watchmaker.
CONTACT INFORMATION
Bravur Watches AB Katarina Bangata 33 116 39 Stockholm Sweden
info@bravurwatches.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>