Cycleinn CI-FT001 Bike Trainer Instruction Manual

Table of Contents

Thank You

For you purchase!

If you have any Issues with the product, please email us at service@cycleinn.com and we will promptly work with you to resolve your issue.

Step 1: Assembly of bike trainer

Step 2: Bike installation

First check whether the tire pressure of the bike is at normal state.
Install the bike on the bike trainer. adjust the T-handle of the left knob to make the bike tire roughly in the middle of the roller. After fixing the bike, push the handle lock ring to the Innermost side, as shown in Figure 7.
Adjust the adjusting knob clockwise to make the roller tightly touch the tire, and then tighten the adjusting knob for one and a half to two turns to make the roller fully fit the tire.

Step 3: Placing front wheel riser block

As shown in Figure 8, fix the standard front wheel fixed seat right below the front wheel of the bike.

Step 4: Trail operation

Confirm again that the bike is firmly Installed and fixed, and the frame is fully fitted with the ground without tilt.
While riding, first step on the crank at a slow speed, If there is no first step on the crank at a slow speed, and then Increase the speed without any abnormality, you can then increase the speed

Care

The product can be folded for storage, Operation method: Close the supporting stand foot in. Pay attention to avoid hurting hands when folding them.
The product shall be stored in a clean and dry indoor environ- ment, avoiding direct sunlight, away from fire and water sources or other dangerous goods.
Just wipe the product with a clean cloth for cleaning. Do not use detergent, cleaning powder or other chemical solvents to clean it, so as not to damage the surface paint of the bike trainer.

When an exception occurs, please check and resolve it according to the table below.

Exception / Reason and Solution

Bike shaking
- The ground is rough, or the user fail to level the bike trainer according to the instructions. Please level the bike trainer according to step 1.
- The handle is not locked in place and the bike Is not firmly fixed
Bike tires are seriously worn
- Check whether the tire pressure Is low and inflate to make up the tire pressure.
- Check whether the roller and the bike are too closely or loosely contacted, adjust according to step 2-3
Noise
- The noise is mainly related to the materials and tread of bike tires. The use of road bikes is highly suggested because the spinning sound will be louder and it possible to wear out the tires if mountain bike is used. We also recom mend using the bike trainer on a carpet to reduce noise.

WARNING

Persons with limited physical, sensory or mental capabilities or those with a lack of experience or knowledge should not use this indoor bike trainer, unless they are supervised or if they have been informed about using it safely and understand the relevant risks of use. Children must not play with the indoor bike trainer or any of its parts. Children may not service or clean the product without adult supervision.
Do not touch the resistance roller during or after training as this can become very hot. Risk of burns Keep children, and animals away from the indoor bike trainer at all times.

NOTICE

Please ensure that the indoor bike trainer is positioned securely only train on a firm, even and non-slip surface Adjust the indoor bike trainer as required using the adjustable stand feet.
Should you experience pain, nausea, dizziness, weakness or chest pains, please terminate your training immediately and consult your GP.

Product Name: Bike Trainer
Product Model: CI-FT001