LEDIP Cold Therapy Inflatable Instructions
- June 15, 2024
- LEDIP
Table of Contents
LEDIP Cold Therapy Inflatable
INFLATABLE
COLD PLUNGE MANUAL
Inflating Cold plunge in 7 Simple Steps:
-
Step 1 Unroll your lceberger
Remove the packaging, unroll your lceberger and locate the grey valve. -
Step 2 Set the valve pin
Turn the valve cap counterclockwise to remove. -
Step 3 Lift the Valve Pin
Inside the valve, you’ll see a pin. This valve pin should be in the upright position before you start to inflate your Cold plunge. When the pin is up, that’s the closed position and when it’s down, that’s the open position. With the valve stem pushed down, your inflatable Cold plunge will leak air once you disconnect the pump hose. By the time you close the valve, the tub might lose a lot of pressure and it won’t be as stiff as it should be. -
Step 4 Connect the Pump Hose
Attach the pump over the pin and twist it clockwise. You’ll know it is secure when you hear it lock. Before you start pumping, check the hose connection at the pump end. Make sure it’s connected to the INFLATE side, not DEFLATE. -
Step 5 Pump it up!
Start pumping! The pressure gauge will register once there’s quite a bit of air in the tub. We recommend inflating to 1 Opsi. -
Step 6 Disconnect the Pump
Disconnect the pump’s hose by twisting it anticlockwise. You don’t need to touch the valve. -
Step 7 Screw the Valve Cap
Screw the valve cap back on.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>