BUNGIE 5497736 Warp CE Kit User Manual
- June 15, 2024
- BUNGiE
Table of Contents
5497736 Warp CE Kit
User Manual
TOWER OPERATION
ON/OFF: Power up the Tower by pressing the Power Button on the left side
of the plaza once. Press the Power Button again to power down.
MODES
Once ON, you may access the operation modes that cycle in the following order
each time the Mode Button on the right side of the plaza is pressed.
Mode 1/LIGHTS: This is the default setting when the Tower is powered on.
Mode 2/AMBIENT: Short tap the Mode Button once after powering up to play
the Tower ambient sounds. Lights will remain on, and audio will loop until the
Tower is turned off or another mode is selected.
Mode 3/INTERACTIVE: Short tap the Mode Button again to enable the Plaza
for interactive play.
Sound Volume can be adjusted with the rotational dial located on the back edge
of the base near the charge port. The Tower’s power bank can be recharged by
inserting the supplied USB cable into the port on the back of the base and
connecting it to a standard USB power source.
Destiny 2: The Final Shape Collector’s Edition DSC23001-100
Made in China.
© 2024 Bungie, Inc. All rights reserved.
Distributed by Bungie Aerospace Corporation, 550 106th Ave NE, Bellevue WA
98004 / Brand Access LLC, Joop Geesinkweg 501,1114AB Amsterdam-Duivendrecht,
Nederland.- +1 877 302 2237.
Brand Access LLC
Unit 1, 26 Liliput Road, Brackmills Industrial Estate, Northampton NN4 7DT
UK customerservice@bungiestore.com
Battery Safety Information:
1000mAh. Input: 350mA/5V. Output: 300mA/4.25V. Voltage: 3.7V. Current: 300mA.
Power: 3.7Wh. USA Contact Information:
- Responsible Company Name: HALO Branded Solutions
- Address: 1500 HALO Way, Sterling, IL 61081
- Tel: 1-425-440-0226
- Email: compliance@halo.com
Handling and Storage of Battery: The battery should not be opened,
destroyed or incinerated, since they may leak or rupture and release to the
environment the ingredients that they contain in the hermetically sealed
container. Do not short circuit terminals, or over charge the battery, forced
over-discharge, throw to fire. Do not crush or puncture the battery, or
immerse in fluids. Storage: Avoid mechanical or electrical abuse. Store
preferably in cool, dry and ventilated area, which is subject to little
temperature change. Storage at high temperatures should be avoided. Do not
place the battery near heating equipment, nor expose to direct sunlight for
long periods. Other Precautions: This battery may explode or cause burns, if
disassembled, crushed or exposed to fire or high temperatures. Do not short or
install with incorrect polarity.
Exposure Controls/Personal Protection of Battery: Use local exhaust
ventilation or other engineering controls to control sources of dust, mist,
fumes and vapor. Keep away from heat and open flame. Store in a cool, dry
place. Respiratory Protection: Not necessary under normal conditions. Skin &
Body Protection: Not necessary under normal conditions. Wear suitable
protective clothing and gloves if handling an open or leaking battery. Hand
Protection: Wear suitable gloves if handling an open or leaking battery.
Eye Protection: Not necessary under normal conditions. Wear safety
glasses if handling an open or leaking battery. Other Protective Equipment:
Have a safety shower and eye wash fountain readily available in the immediate
work area. Hygiene Measures: Do not eat, drink, or smoke in work area.
Maintain good housekeeping.
Toxicological Information of Battery/Irritation: Risk of irritation
occurs only if the cell is mechanically, thermally or electrically abused to
the point of compromising the enclosure. If this occurs, irritation to the
skin, eyes and respiratory tract may occur.
Manufactured By: Shenzhen Top Energy Co., Ltd.
Address: Room 101, 201, 301, Building A, North Temple KOK, NO. 11, Gaoyuan
Community, Kwai Chung Office, Dapeng District, Shenzhen City
**Battery Use/Care/Maintenance
**
Do not open, disassemble, crush or burn battery as it can be harmful. The
battery should be charged about once every six months to prevent over
discharge.
Recommended storage is at room temperature, charged to about 30% – 50%
capacity. Do not heat above 70⁰C or incinerate, deform, mutilate, crush,
disassemble, overcharge or short circuit the battery.
FCC Information FCC ID: 2A2JI5497736
WARNING: Changes or modifications not expressly approved by the party
responsible for compliance could void the users authority to operate
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio TV technician for help.
PATCH
Made in China
Adult Use Only. Not Intended for Children. Not a Toy.
For Promotion Use Only. Not For Resale.
-
CAUTION:
– To prevent burns and other injuries, do not touch hot iron.
After ironing, the patch and surrounding area will be warm or hot to the touch – let cool completely prior to use.
– Prior to ironing patch onto item, ensure the item’s material is suitable for high heat. Ironing is not recommended for materials that may be damaged by high heat such as leather, rayon, spandex, nylon or other delicate fabrics.
– Remove sticker before applying.
– Must be applied by adults only. -
APPLICATION INSTRUCTIONS FOR STANDARD HOME IRON:
– Set iron to High / Cotton / No Steam Setting.
– Lay item on flat, heat-resistant surface.
– Place patch on item and cover with a thin cloth.
– Iron 30 seconds using constant pressure and twisting motion over entire patch, paying special attention to edges and corners.
– Repeat on reverse side of fabric.
– Let cool completely before use.
All Other Items – Made in China.
Distributed by Bungie Aerospace Corporation, 550 106th Ave NE, Bellevue, WA
98004 / Brand Access LLC, Joop Geesinkweg 501, 1114AB Amsterdam-Duivendrecht,
Niederlande.
Destiny In-Game Item Code Redemption:
- Please visit https://bungie.net/redeem and login into your bungie.net account, or create a new account.
- Enter the unique 9-digit code and click the “ENTER” button.
- The code you entered will be automatically applied to all your account’s linked platforms.
- Follow the instructions on the website after code verification to pick up your item in-game.
Visit the DESTINY CODE REDEMPTION GUIDE at
https://www.bungie.net/en/Help/Article/12131 for more information.
Destiny 2 game required to access the specified item.
Destiny 2 game installation required to access code. This item is only
available to those with a Bungie.net account who are 13 or older. Code is not
redeemable for cash, cannot be returned for cash or credit, may not be used
for any other purpose and will not be replaced if lost, stolen, or damaged.
The voucher code (“Code”) is good for one qualifying account to redeem the
Code to download the specified emblem.
© 2024 Bungie, Inc. All rights reserved. Destiny, the Destiny Logo, Bungie and
the Bungie Logo are among the trademarks of Bungie, Inc.