BD10500 Pipedream Oval Remote For Body Dock Instruction Manual
- June 15, 2024
- Pipedream
Table of Contents
BD10500 Pipedream Oval Remote For Body Dock Instruction Manual
INSTRUCTION MANUAL
- This remote include ten frequencies vibration, include 3 speeds and 7 vibration modes. usage method: Hold the button for 3 seconds to turn on the remote, and short press the button, motor start to vibrate.
- short press the the button(or remote) to switch the vibrationspeed and frequency(cylic vibration).
- Hold the button for 3 seconds to shut down. Charging method: Charging with cable, the indicator light flashes and stays on whenfully charged.
Warning:To Avoid Battery Leakage
- To recharge the vibrator, please only use the USB cable provided in the packaging
- Please recharge the vibrator for 2 hours before initial usage.
- Do not short the terminals. Connection to improperly grounded equipment can result in short-circuit.
- Use of non-original manufacturer-approved accessories may damage the product and cause explosion
- Recharge the vibrator at room temperature.
- Store in a cool and dry place.
- If terminals are soiled, clean with a soft cloth.
- Unplug the USB cable when the vibrator is not being recharged.
- Keep the vibrator from heat.
- Keep the vibrator out of reach of infants or children
- Prolonged use is not recommended. When the vibrator gets warm, stop and cool the vibrator down before you use it again.
- Retain packaging and instructions for future reference.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
nonguaranteed that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
The devices has been evaluated to meet general RF exposure requirement the device canbeused in portable exposure condition without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>