Liderlamp VT-4102 Solar LED Garden Light Instruction Manual
- June 15, 2024
- liderlamp
Table of Contents
Liderlamp VT-4102 Solar LED Garden Light
TECHNICAL DATA
- MODEL: VT-4102
- SKU: 10304
- LUMENS: 220Lm
- BEAM ANGLE: 1100
- BODY TYpE: ABS
- DIMENSION: 720x155mm
- BATTERY CAPACITY: 2600mAh, Li-ion
- SOLAR PANEL DATA
- SOLAR PANEL: DC 5.5v, 3W, Polycrystalline
- CHARGING TIME: 6-8 Hours
- WORKING TIME: 10-12 Hours
INTRODUCTION & WARRANTY
Thank you for selecting and buying the product. will serve you the best. Please read these instructions carefully before starting the installation and keep this manual handy for future reference. If you have any other queries, please contact our dealer or local vendor from whom you have purchased the product. They are trained and ready to serve you at your best. The warranty is valid for 3 years from the date of purchase. The warranty does not apply to damage caused by incorrect installation or abnormal wear and tear. The company gives no warranty against damage to any surface due to incorrect removal and installation of the product. This product is warranted for manufacturing defects only.
WARNING!
- Installation must be performed by a qualified person.
- The light source Of this luminaire is not replaceable, when the light source reaches its end Of life the whole luminaire should be replaced.
- Replace any cracked protective shield.
- Don’t immerse in the water
- Luminaire cannot be installed in low-lying areas, so as not to soak.
WARNING: This marking indicates that this product should not be disposed
of with other household wastes.
Caution , risk of electric shock.
INSTALLATION DIAGRAM
INSTALLATION INSTRUCTIONS
- Fix the lamp on the grass.
- Press the switch to start the working mode.
- Adjust the direction of light.
- Adjust the solar panel to face the sunlight.
MAINTENANCE
- Clean the light with a dry, lint-free cloth.
- Check the solar panel for dirt regularly. If dirt is present remove it to guarantee flawless function of the product.
- Especially during the winter, keep the product free from snow and ice.
- Confirm installation direction is correct.
- Confirm no objects blocking the solar panel from receiving sunlight
FUNCTION
- Switch setting and working mode: Long press the switch on the lamp panel for 2 seconds, it will turn on (the blue indicator light is always bright in the startup state, regard ess Of day and night). It will enter mode 1, in which the blue indicator light is steadily on, and if you long press the switch for 2 seconds, then it will turn off (the blue indicator light goes off in the shutdown state).
- Working mode: In the state of startup and setting working mode, automatic charging will not turn on the light during the day but only at night; In the off state, the automatic charging will not turn on the light during both day and night.
UNDER STARTUP AND SET WORKING MODE, THE WORKING MODE IS AS FOLLOWS:
- Mode 1: At night, the luminaire shall maintain a low brightness of 5%; when the lamp detects a person
- within 3—5 meters, the lamp will turn to 100% brightness: when people leave the sensor range of the lamp, the lamp will keep high light for 25—30 seconds, and then turn to 5% low light. when no one Is detected in the sensor range of the lamp, the lamp will keep 5% low light. It can last more than 12 hours in low light.
COLOR TEMPERATURE CHANGE SEQUENCE:
by default at 3000K, press to 4000K, and then press again 6500K.
MULTI-LANGUAGE MANUAL QR CODE
Please scan the QR code to access the manual in multiple languages.