Flame King Propane Tank Gauge Level Indicator Leak Detector Gas Pressure Meter User Manual
- June 15, 2024
- Flame King
Table of Contents
Flame King Propane Tank Gauge Level Indicator Leak Detector Gas Pressure
Meter
INSTALLATION
- Easy to install; no tools needed.
- Ensure all burner control knobs and cylinder gas are turned-off
- Disconnect the regulator or high-pressure system from the cylinder
- Connect the Gas Meter to the cylinder valve by tightening it securely with the gauge in a vertically upright position as shown in Fig. 1. DO NOT USE WRENCH TO TIGHTEN.
- Connect the regulator or high-pressure system to the Gas Meter
- Install under protective cover to prevent rainwater from entering the Gas Meter
“LEAK TEST” Procedure
Note: Never use LP gas without testing for leaks in the system
- Turn OFF the gas supply at the cylinder.
- Turn OFF all appliance burner controls.
- With the appliance burner control(s) in the OFF position, turn the gas cylinder valve ON. This pressurizes all lines to the appliance(s).
- Now the gauge should provide the tank level reading.
- If it still does not indicate the tank level, you are out of gas or have not connected the gauge enough to get the reading.
- Watch the needle position on the gauge. Wait for around 3 seconds and then CLOSE the cylinder valve. The Gas Meter now monitors the pressure between the cylinder and the appliance.
- Any leaks in the lines between the cylinder and appliance will be indicated by the needle movement toward the Red Colour.
- If you find a leak, DO NOT USE GAS.
- To detect a leak, apply soap solution to all connections and look for bubbles. An expanding bubble or bubbles indicate your leak.
- Repair all leaks before using gas cylinders or appliances. Re-tighten where bubbles appear, and recheck for leakage using the soap and water solution.
- If bubbles persist, you still leak. STOP: DO NOT USE the propane cylinder or appliance(s). Have a qualified propane service person recheck your propane system and correct leaks before using the propane system outlet.
WARRANTY
YSN Imports Inc., warrants your FLAME KING'” Gos Meter to be free from defects in materials and workmanship for one year from the original purchase date. Should the product have a defect in materials or workmanship, we will repair or replace it without charge to you. A shipping and processing fee may apply. To obtain services under warranty, simply contact our Customer Service Center at worronty@flomeking.com or via our toll- free line at 877-425-6508. This warranty does not cover any damage caused by accident, misuse, or any use intended and described in this owner guide, or damage resulting from failure to maintain this product as specified in the manual.
TO DETERMINE GAS LEVELS
The Gas Meter gauge is read while gas is flowing in the system. It indicates the propane level in the tank only and will not indicate the exact tank level.
If the needle points to:
GAS: There is still plenty of the tank
LOW GAS: Early warning of low gas in the tank
REFILL: The tank should be refilled to avoid out of while cooking
Depending on the outside temperature vd-en Cas shows REFILI has colic 10-15 minutes of propane left.
REMEMBER: Use propane for at least 5 minutes before checking for low gas
levels. It is best to read the gas level just before finishing using the gas
appliance and check the level to refill before the next use.
Note: Before refilling or exchanging your cylinder, remove the Gas Meter
for reuse with your new or refilled cylinder.
Gauge display based on temperatures:
Even in low temperatures propane gas can be used. In extremely cold weather
conditions (-23°(/-10° F), the propane in the cylinder may not vapourize as
quickly as required, thus the gauge will read in or about the yellow zone.
HANDY HINTS
- Before starting, make sure all gas controller ON/OFF knobs are turned off on the appliance, then turn on the gas supply.
- Lean the Gas Meter at a slight angle to prevent rainwater from entering the device.
- If condensation forms under the gauge dial, take the Gas Meter off and place it indoors until the condensation dries out, then replace back on the system.
SAFETY PRECAUTIONS
- The Gas Meter should be installed by a competent adult
- Install the Gas Meter in an open and well-ventilated area
- Do not use any open flames, matches, or fire nearby when installing, connecting, disconnecting, or testing The Gas Meter
WARNING: Improper use of this product may cause an explosion or fire resulting in death; personal injury or property damage. Read these instructions carefully before using this product.
RETAIN THIS BOOKLET FOR FUTURE REFERENCE.
Flame King
8616 Slauson Avenue Pico Rivera, CA 90660 1-310-715-1 122
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>